Viewing all customer Discussions for:

39-413 Offset Single Arm Operator, 9-1/2

Need [R] and [L] casement parts. 30 year old parts need total replacement

Looking for replacement window crank for casement windows

Hello, I need a window operator that will fit with the strike plate on it. See my pictures attached. The arm is straight.

I'm looking for window crank handle replacements. To right side and two left side. The product has an etching on it from Nordic, apparently the manufacturer. The home was built around 1980, and this is the original window hardware. From the point about which the crank pivots to the tip of the cra ... (cont.)

Need replacement parts for casement windows for both left and right side. I have included pictures of the left side casement so would need part number for right side as well. The mechanism arm is 7.5" from the bend to the roller. Also, looking at Outside Pic2.jpg shows the mechanism mounted with ... (cont.)

Need handles to fit Truth casement window operators; your #39-013

Need help with selecting the correct replacement guide loop that attaches to the truth 30752 operator, (or selecting a new kit) and also need new folding handles

These are windows from 1972, wood framed. I'm not sure who the manufacture was. the handles appear to be stamped 'CAPADCO' I didn't see any that clearly matched on your Website.

Do you guys carry this crank? No markings on window

I am needing covers and cranks for Jeld Wen Casement windows with this hardware. I am looking for both left and right versions in white with a folding handel/crank.

I'm looking for this part of window

Need replacement.

I need a right hand and a left hand operator for the windows that do not have any identification on them . I don't know how you're measuring from to get approximately nine. It could be 9 and 1/2 or 10 but I measured from the bend

Need to replace the crank mechanisms for both the right and left Norco casement windows. The single arm is offset, and based on measurements should be 9 1/2 inches. Mounting base dimension: center to center distance between outside mounting holes on back (window side) of mount is 3". Present cran ... (cont.)

All It has marked on it is Anderson. I just need something to replace this not sure it matters the brand.

The Bracket on the exterior of the window #3 closed side snapped. I am trying to replace the mechanism instead of the window. Can you help me with the parts I would need?

I replaced my c.1985 Truth casement window operators on ten windows last year using 39-014 and 39-013 operators. I now am replacing six on the same brand of windows but they are narrower and have 9 1/2" arms instead of 13 1/2" arms. I think the same operator with the shorter arm are 39-412 and 3 ... (cont.)

The part has Truth 45251 stamped on it. The arm is 9" long when measured from the gear. It has Norco stamped oh the crank.

Norco wood casement window. D Series JEL N 329 Need left and right cranks. Also need 2 sets of hinges for the same type windows

Hello also looking for cranks, crank arms and window keeper and slide keepers as shown