Viewing all customer Discussions for:

26-244 Tilt Window Latch, Right Hand

Hi, do you know where I can find this Harvey window latch replacement? I tried one from Home Depot but it does not match. Thanks, Joe

No markings. Might be H&H window??? Looking for replacement parts for multiple windows.

Hello, I need to replace the sliding part on top of the window sash that seems to have a spring in it. In this photo it is the oval part to the left of the window lock. The one that is broken is actually on the right side of the window (if they are location specific).

Manufacturer: CDI The top of my sash window falls out of the frame. The photo shows the part that is missing the tongue latch, I think. I believe this is why the top of the window falls out of the frame.

The latch is at the top corner of the bottom window. The protruding plastic piece (which holds the window into the window frame) is broke on both sides where it latches into the window frame. They were installed in 2009. My name is Babette

Hi, these were originally purchased from home depot, american craftsman, about 15 years ago. Sizes is 2 3/8" x 11/16". Need both right and left side.

Hello,Thank you for the assistance on my balance coil. Installed and working.I now need a left and right tilt latch for my B.F. Rich double hung window.Pictures are attached.What part should I order?Thank you.Rob

I need to order 32 of these so I'm hoping to get it right the first time,any help would be greatly appreciated

Unable to determine actual size needed

Looking for these specific parts! I am in need to replace parts for a total of 9 windows. Looking for 18 total latches and 16 total locks. The latches measurement is 2 5/8 inches width 3/8 inches in height 5/8 inches in depth The lock measurements are 2 3/4 inches in width 1 1/8 inches in depth T ... (cont.)

I need help identifying a replacement for my tilt latch. I have a handful of them broken, but I removed and photographed an intact one (pics attached). I looked at your 26-243 and 26-244 because they have the same DIMENSIONS (2 5/8" x 11/16") and quite similar design. Two issues: 1) MINOR - the l ... (cont.)

Hi Experts! I have vinyl windows with locks on the top middle that read VIKING. The latches on the right and left side both have the little triangular lock part broken off. They measure, on the top, 2-1/8" long and are 3/4" wide. They bend over the edge of the window on each side, so the whole piec ... (cont.)

See photos...hoping you can assist in identifying the correct replacement Tilt Window Mechanism for these Simonton Windows. We have several in need of replacement. Thank you

I included the Patent number engraved on the actual part which I included in the photos. The part measures a little over 2.5" in length but with the actual pointed clip measures 3" in length. Width is not quite 3/4". I need clips for 4 windows (right and left).

broke the center part on top. it is 3.25 in x 3/4 in it slides into the top right side of the window as a lock

Need help to identify this clip

Both latches on top and both pivot studs on bottom of sash need replacing. Window was from 2010. Need recommended parts. Bernard

Its a cold time of year to have windows falling from their frames; searching for possible replacement hardware. Have several windows that are allowing large cold drafts.

just wondering if you knew what this part is called and if you have any ..thanks

I purchased several 26-393 pairs to replace broken tilt latches, but they wound up not being quite the same. No identifying marks on existing latch, but hoping a suitable replacement can be found based on the pics. Thank you!Dave