Viewing all customer Discussions for:

26-244 Tilt Window Latch, Right Hand

Can you tell me which tilt latch I need to purchase

Need to replace both right and left tilt latches, pivot shoe and spiral balances for a set o patriot windows.... Hoping you can help nail down the exact parts.... Any help is greatly appreciated.... Rich

RSVP double hung window tilt. Can you tell me where I can buy this latch? Pat. # 5.139.297 .092

need 12 of each side (L and R) window tilt lock. I believe they are part number 26-243 and 26-244. Please compare to the attached picture next to a scale and email me back so I can order Thank you Elias

I am needing to replace some broken tilt latches and they look very similar to the model 26-244 & 26-243. The only identifing mark on the existing ones are the number 375 on the bottom and a large letter P on the bottom body

I previously ordered Top Tilt Latches for my Alcoa windows. The latches I ordered are too long. I am attaching photos so I can order the correct parts.

I believe these are probably the right latches for my windows (26-243 & 26-244) but there are a couple of differences I want to ask about. Cosmetically, the latches I have have a big "R" or "L" on them. No big deal,I'm assuming this is simply because yours aren't the exact brand. The measurements ... (cont.)

I need 6 pairs of these for a customer in Marlton, NJ. Also attached are photos of the spiral lift rod. It had a plastic cover on it originally, but it is falling apart. The overall length from the blue tip to the end of the rod is 27 3/8" The width of the metal portion of the rod is 7/16". I b ... (cont.)

I took some measurements and it looks like my damaged window latches match product code 26-243 and 244. The latch slides into a groove on the window. A sticker on the window casing indicated it was a monton window. Please look at the pictures to see if you agree. Also, I need to replace a coup ... (cont.)

Hello, I am looking for a part for an Alenco window-both right and left latches. About 2 5/8" length, 11/16" wide, just under 1/2 inch deep. On the bottom of my part is the letter "R", with "28" just below. A "96" is also there, lower down. Please see attached photos. Do you have this available ... (cont.)

I'm looking for replacement parts for my Alcoa windows that were installed when the home was built new around 1996. The windows are white and the spiral balances have a white casing. I've attached a couple of pictures, but I'm not sure what series/model windows I have.

I purchased a house a year ago and there is no sticker to identify the window brand I need to get some pivot bar and pivot bar holders for the bottom of window. The top part takes your part number 26-243 and 26-244 and the bottom slot looks the same as the top and that they modified the top pieces ... (cont.)

I HAVE SOME OLDER ALENCO WINDOWS, SERIES 385 DH R30 MST 3860, I NEED 16 TILT LATCHES FOR THESE WINDOWS, I CAN'T FIND THEM ON YOUR SITE, I NEED THE SCREWS ALSO, PLEASE HELP, I CAN SEND THE PART IF YOU GIVE ME YOUR ADDRESS...THX ROBIN

Do tilt latches 26-243/244 come in white only?