Viewing all customer Discussions for:

58-114 25ft Kerf Mount Bubble Seal, 3/8"

morning wondering if you have these parts? the windows were installed in 1989 this is all the info I could get off them. thank you.

I am looking for replacement weatherstripping for Pella Architectural Series double-hung windows that were manufactured in 2000. Thank you.

Looking for this seal for Apollo low-H 94-4 windows

I emailed earlier, but the attached files for the pics were too much.

I have sent 3 photos. The first two show the only part left that is intact. The "flat" plastic section goes into a slot along the outside of the lower window frame near the bottom. Then the bubble tube folds under the window. You can see the slot in the third photo. The length of the whole piece is ... (cont.)

I need the window seals for Kolbe casement windows that crank out. I think it is 2/8", but it is torn and distorted.

Looks like it's all one piece and can't find a replacement black bottom piece

Need Parts

See photos

Good afternoon, I am looking for a piece of weather stripping for a Milgard Trinsic double French door. Please let me know if this is something you carry. Thank you, Phil

I need to replace the weather stripping for four sets of double outswing doors, all of which are 8' in height. The larger weather stripping shown in the photos goes around the perimeter of the doors. The smaller weather stripping goes on the astragal of the doors

Door frame seal for paella sliding door. 3/8 bulb size 5/16 stem size

Total width flattened out with fin 5/8" / bulb measures 3/8" flattened out / I need 4 pieces 57" long and 4 pieces 27" long

I need to replace the rubber weatherstrip on our Pella double glass doors. I believe that it is the 3/8 inch gasket that you sell but want to be sure before ordering. The doors are wide, tall double pane sliding glass doors installed in 1992. Thanks

Do you have a comparable weatherstrip to this? See photo. Thank you

I have about 40 casement windows needing weather seals. the original is pressed into a kerf directly adjacent to the metal window frame. It measures 1/2" inch.... 5/16" press in kerf and 3/16" hollow window seal. By 5/16" wide

The Pella weather strip that you show does not look like mine. Do you have the type in photo?

Pella door gasket door #0501 PLCSCVF1Z1-072A081AWHT-615S-NFRC

Hi: Can you please advise a replacement product for the Kolbe and Kolbe weatherstrip shown in the photos? The dimensions are very very close to this product from Swisco, but there is no foam inside your product. Thanks!

I have a wooden Pella sliding glass door. I'm assuming it is circa 1990s? Maybe older? I am looking to replace to the weatherstripping all around the door and maybe get a little more life out of the door. What type do you think I should get?