Viewing all customer Discussions for:

84-074B Screen Door Roller, 1" SS BB Concave

Which would work best to replace the uploaded item?

Do you have this runner. Ideally one that can withstand coastal weather.

2.5" approx in length

I have a screen door 36x93 with 2 rollers on the bottom corners and 2 on the top corners. I live in IL and no surprise that the bottom ones in particular are not rolling like they should. I picked up a set from ACE that are Prime-Line B 702 but know they too will rust and the screws for mounting lo ... (cont.)

Hi, I live by the pacific ocean so its always foggy here and Ive had all my rollers rust out in in about 2 years since installation. Which would be more rust resistant, this stainless steel or the nylon version here: https://www.swisco.com/1-Nylon-BB/pd/Patio-Sliding-Screen-Door-Replacement-Roller ... (cont.)

I'm looking for patio screen door replacement wheels (this is information was on the label in the patio window that was installed photo 1 shows the actual label: the window series 9500 Vinyl Patio Door PL# 073-302 the AAMA code: ADW-4. The photo 2 is how the wheel was installed, photo 3 is how it lo ... (cont.)

I just received my order. However, the rollers do not fit as they are not the same as my existing rollers. As you will see in the enclosed photo's, I have a plastic spacer that goes between the roller and the door with two mounting screws and a center adjusting screw that screws into a threaded hole ... (cont.)

Looking for 4 screen door rollers

Below is a picture of my old roller. It is 1/2 in high opposed to the 3/4 in high 84-066 which I purchased. All other dimensions are the same. Will it work?

Need to order these!

There are two on the bottom of the door and two on the top. I need to replace the rusted ones on the bottom

in addition to a roller of this style, there is a plastic riser that sits atop this roller. It has holes for mounting screws to pass through. it is a necessary spacer for the roller to reach the correct position inside the frame. it encloses the adjustment screw at the top of this roller and protru ... (cont.)

This is the screen door to the 12 foot slider you've been helping me with. I'll be ordering as soon as I get this question answered. I have taken the screen door off for the roller here. Are the photos just need to know what type of roller I would like to replace it with metal rollers not nylon whi ... (cont.)

Purchased the above but unable to find the correct video to install them. One video said it was for this one, but showed a different number part installation. Can you help me? Thank you.

My rollers are similar to the swisco 84-066 except the 1/2" body height

I need four roller-wheels for aluminum storm doors. I have a pic but will have to send it later. Where do I look on the site?

How do I determine what I need (see picture)? ? Thank you. ? Pierre

How is the 84-066 roller height adjusted? The 84-502 Adjusting screws won't work.

Hello. The dimensions of existing wheel assy. are: 1" wheel, 1/4" wide; mount bracket is 5/16" wide, 1/2" tall at tallest point, 2 1/8" mount hole spacing ( 1 1/16" from either side of adjusting screw. Purchased 84-074B and the diameter of the wheel was too small then purchased 81-266 and the whee ... (cont.)

From a Vision 2000 sliding screen circa 2000. I think it is 84-074B. Measurements all match both. 84-074 is very similar except the rivet head are on the wrong side and it specifically says the wheel thickness is 1/4 inch. My part seems a little narrower. So which one?