Viewing all customer Discussions for:

26-393B Tilt Latch Pair

I have attached the photos I have available. The builder said they were Jeld Wen windows. I need the side spring assembly with the small weather stripping piece.

I am having trouble identifying my replacement window latch Please help me identify it. See photos Thanks

I have several silverline windows (circa 2005) pivots, tilt locks, pivot bars and channel balances need replacement.

See attached picture can you verify what I need to order to fix my window. The clip that holds the slide is broken and I want to order more white locks shown in picture.

I inherited a house, the windows are double pane, probably 10-15 years old i would say. During the last hurricane, living in Daytona Beach, a window blew out and broke, i had the glass replaced, and did not realize that the lock and sash were broke as well. I have searched high and low to find the ... (cont.)

Home built 2001. No id/mfg on any window. Broken tilt latch measurements: - 2 3/8 Long - 11/16 Wide on Top - 5/16 Deep - No screw holes

I am looking for a replacement tilt latch. Left and right. Slot dimensions cut in window are .560" wide X 2.570" length. Slot depth is .410" Slot has full radius cut in end. What would be the part that would fit these dimensions? Thank You, Scott J.

Metal pivot pin says 1074 on it. Also lock mech jousts slips in groove.

Looking to replace the broken castings. Quantity 6

hi: i cannot find window tilt latch or balance coupling after looking at all the local HW stores. Mine is shorter than all the latches available. Can you help please. For the latch the end to end length is 2 5/8 . the length without the tip is 2 3/8 . It is 3/4 wide outter edge to edge, and 3/8 i ... (cont.)

Inside parts for window sash

I am need of this part for 2 of my windows. I cannot get it apart to see the sliding part so I need the whole assembly? Please let me know if you have these. I would like to buy 5 of them.

I need a tilt window latch. I found a couple that were close but the spring underneath is not in the right place. It's also ivory. Thanks for the help!

I ordered Part# 26-442 (Truth Tilt Latch Set) to replace a broken RH tilt latch (see attached pic). All of the dimensions on Part #26-442 were correct; with the exception of the top plate. It stated that the top plate was 2-5/8; however, it was more like 2-1/2 (see attached pic for comparison). Pa ... (cont.)

Can you recommend a part to replace these? Thanks

We have old tilting windows and need new latches. Measure 2 5/8 x 5/8. Don't see that measurement on your website. Help! Thank you. Charlotte

Here is a picture of the tilt latch I need. It's dimensions are 1 5/16 x 11/16 x 3/8. The dimensions of Product Code: 26-420 seem right, but the overall design is a bit different. Do you think it would work? If not, do you have any other ideas? Thank you, Lynn

Looking for 4 of the attached picture

I ordered part 26-393 - order 915237. We received the parts and installed them, but had to shave off part of the latch because it wouldn't work otherwise. I noticed on one of the old, broken pieces that 00 is on the under side. I've attached the pics. Is the piece you sent the true replacement p ... (cont.)

I need help finding a replacement part for a customer. I cannot find anything that matches these dimensions - there are no identifying marks on the customers window.