Viewing all customer Discussions for:

26-450 Pivot Bar

Hi, These are two examples of what I need but I do need many. One has what looks like a 4 etched in it and one has a 6 but otherwise they seem identical. overall length seems to be 2 7/8" between the holes is 1" from head to first hole is about 1 7/16 - 1 1/2" - it's a little warped so hard to get ... (cont.)

I needs size 3 1/8 inches pivot true bar

attempting to fiind bars for windows. see measurements in photo description

The bar is 2 - 13/16 " long the outside screw hole is 1 - 7/16" in and the second hole is 2 - 7/16". The measurement for the holes are to the center. There is the number 5 in a circle to the outside of the outer most screw hole. Both screw hole appear to be threaded and the screws do not appear to ... (cont.)

Hello, I am looking for pivot pin replacements for my Paradigm tilt in double hung windows. I cannot find anything that is the same. Do you have any suggestions?

This is in a polaris window. Do you have a replacement part for this type window from 2002. I do not have the piece out of the window yet. I will. I will send with dow specs if that helps out.

Cant seem to find the correct coil ballast the stamp looks like a 10 with a J underneath it?

Need to ID and order replacement parts. The two pieces that hold window in place.

Need to replace pins, latches and latch slider parts. Please identify.

Windows manufactured by paradigm Please let me know if there is a part # that lines up with this Thank you Jared

Hello, I am looking for this piece for couple of our windows.

Do you carry these?

Hi, I thought I'd ordered the correct replacement pivot bar (265B) but apparently I was unaware that the former bar had threads in it. The hole on 365B is also just ever so slightly smaller than the old screws. The hole lines up fine with the existing one on the sash, so other than these issues I ca ... (cont.)

Need an early pivot stright pin for a Harvey replacement tilt window. The pins first is 1" from the pin head . There are two holes.

I am looking for this style of pivot bar. It is broken and am unable to provide measuremnts for the length. However, the body is 1/8" thick.

Paradigm windows that won't stay up. Looking g for pivot bar. Serial# 104757-1.

Hi, this is a pivot pin that was bent and broken on a window sash. It is approximately .25" wide and it came out of a window that had a "Trinity" label on it from 2004 I believe. Both pins (each side) were bent so that it wont fit into the pivot shoe on either edge of the window. The other pictures ... (cont.)

It says 25 on the back. And a 6 or 9 on the topKarenMy husband says it is not the right one. It won't fit in the shoe. The bigger end

I could not locate this item on your website. I will need 24.

I'm looking for replacement pins for these windows , tilt sash double. I've pulled both upper and lower and cannot find a manufacturer Length 3 1/8 Holes from inner end 3/4 and 1 3/4 Thank you