Viewing all customer Discussions for:

32-012 Rear Drawer Track Socket Pair

Looking for a rear drawer socket like in you picture of part 32-119 but needs to be 1" opening for drawer slides which where new for me in 1999. could not find opemning size in your information

Hello I'm trying to find the push in Adar left & right back drawer sockets. Dimensions: 3.5" Long 1" Rail Insert Opening 1.5" w x 2.5 LBack portion that sits against the cabinet

Our home is 13 years old, and we do not know the manufacturer of our kitchen cabinets. The top drawer that contains our silverware is not usable due to the back pieces of the drawer rail guides breaking, and the top of the piece that holds the drawer down has broken off.. The inside drawer dimensi ... (cont.)

The bracket cracked in half and can not be glued or repaired. Unable to anything else that fits. It measures 2 1/2 inches long and about 1 inch wide. There is a slit on the back of the plastic where it attaches to the hardware in the back of the drawer.

No markings at all.

I'd like to know where to find this replacement part or what is a suitable substitute. Thank you.

Looking for 1 1/2" deep rear glide socket for Merrilat base cabinet.

The brackets broke on the back of the middle drawer in the wardrobe in the bedroom. I placed an order for what I believe is the correct parts. Please confirm.

Hi! I replaced this about a year ago, but the piece failed. I need to replace it again. I've attached the picture of the broken piece and the ones that are working. Please let me know what other information you need. Thanks!

I seem to have two different types. The one piece has 471037 on it. The two piece has 3808 on it. Bought used cabinets and can't find brand. Able to help? Will use something else that works if can't get original. Thanks, Steve

Dear Swisco, I just bought a house which has kitchen cabinets Code: MC-2 under KCMA certification. In one of them the rear sliding push in bracket broke and I can't find a replacement. It is plastic, it is a push in type which goes in a hole about 1/3 inch; it id like those car fasteners easy to pu ... (cont.)

My home has a ton of old blum cabinets systems. Now things are breaking due to age, wear and tear. I've been looking rear mounts for a specific slide. I took photos. I'd appreciate any help you can provide

This part is smaller than my rail "C" What part number do I need for a one inch rail? Thank you, Norm

I need some sockets, or back plates for K & V drawer slider KV 1 300. K and V sent me some but the "necks" aren't long enough. The width is 7/16" and I need a "neck of about 2".

Looking for the above in the following measurement 1" 7/16 x2 1/2" inside measurement where the track goes is 1" the slides are around 20 years old including the Rear Drawer Track Socket. I've had a couple break. Any suggestions

searching for replacement bracket a left and right side. Number on part is 471029

I need 4 drawer track back plates that will fit guides with cross sectional dimensions shown in the photo. I purchased product code 32-089 a while ago, but the 3/8" dimension of those plates is not quite wide enough. Do you have any plates with 7/16" or 1/2" cross sectional width? ... (cont.)

I have older cabinets and looking for replacement parts for the drawer slide stops.

11/4" X 2" plastic

Here are some pictures of the bracket. The u part measures 21/64. The u part is not smooth as you can see from the pictures. It has a small step in it. The length of the u part measures 15/16. The back flat part with the holes in it measures 1 15/16 x 1 1/4 in.