Viewing all customer Discussions for:

32-012 Rear Drawer Track Socket Pair

Do you have a rear bracket like the 30-012 with dimensions of 1 1/2"D, 7/" opening and 1/2' wide..

plastic back plate split at top and bottom causing drawer rolling track to fall and rendering drawer unusable for normal use. the part I need replaced (the back plate) part is # P-5850-23. No number on the open rectangular piece into which the end of the track inserts and is tongue and grooved to th ... (cont.)

Just hoping you have these brackets

I am trying to find a replacement part for a busted rear drawer slide bracket. Image #1 shows the part in full working order for the left side of the drawer. The part for the right side of the drawer is broken in two places. In picture #2 you can see the bracket attached to the wall - the top plasti ... (cont.)

Fits in the back of cabinet for the rail to be supported.

These are parts that need to be matched to attach my kitchen drawers to the backs of the cabinets. I ordered, what I thought were the correct parts from you three weeks ago only to find out they did not have that small extension piece shown on the pictures. Thanks you

I ordered that part(32-012 but it is too long. I think on ur web site as so many people were mad because they r not making the exact part anymore

looking for rear drawer socket part number PPW097 ? if the unit is attached with the brackets i want the hole unit

Broken Rail Bracket for sliding shelf. There are some letters on the rail: KV and CR. The bracket is about 2 5/8" long and 2 1/2" High. The rail itself is 1" high and fits into the bracket.

What screws would you use to fasten this bracket. My bracket was not fastened with a screw; it fit into holes in the back of the cabinet.

I am 1n receipt of my 32-012 order #1442290 - Thank you. My immediate interest is with the Left 32-012, which is comprised of a "back-mount" piece and a "rod-holder" piece. These 2 pieces are pre-assembled as shipped to me. I only need the rod-holder piece (my existing one is broken) to mate with ... (cont.)

There are no numbers on the plastic sockets or on the slide. This is probably a 1980 product.

I'm looking for a drawer socket to accommodate the narrow flange that reaches down from the bottom of our track. We have several drawers that are failing.

Swisco brand

Looking for a replacement drawer guide boot for a 1980s Scheirich cabinet. This is the plastic piece shown at the bottom of the picture. It is used to connect the cabinet slide (shown in top of picture) to a metal piece in the back of the cabinet (shown in the middle of the picture). The plastic ... (cont.)

Hello! I'm looking for a replacement part for the back drawer mount. Rails have Unigrams 6600 stamped on them but I don't what the exact model number is. This piece is 30 years old so I'm positive there's a different part I need to replace it with, I just can't figure what it is. Any help woul ... (cont.)

Trying to locate replacement parts for these broken pieces on kitchen drawer. Do you recognize these?

Looking for something to replace this breaking off. House built in 1991.

will the part 32-012 a good replacement?

For my kitchen utensil drawer. These have tabs on back that go into holes.