Viewing all customer Discussions for:

58-056E Swinging Door Compression Foam Seal

I am unable to identify the glass door manufacturer.

Hello,I am having trouble locating the correct door seal. Could you please take a look at the pictures and measurements below and let me know if you have something compatible?Thanks much,Ron

looking to replace these type of weather stripping into Marvin outswing French Doors. If you can provide the part numbers for each, greatly appreciate your assistance. Thank you

Desperately looking for this weatherstripping. Much smaller than those sold at Home Depot etc. Says Q Lon. it is for a PGT vinyl french door. Thank you !!!!!

Dear experts, Total width: 1" Middle tab length: 9/16" Left tab length: (folded) 1/2" The right 1/2 of the T top goes into the kerf I appreciate your help finding replacement for the above weather stripping. Merry Christmas to you all, Allen

Hurd patio door. Snap in Threshold gasket.

Hi:I recently had a Jeld Wen door installed in between my garage and mud room. The contractor did not install all of the weatherstripping and has been no help remedying the problem. The door is Jen Weld model JEL-M-2-03772-00001. Jen Weld advised me that your company supplies the weatherstripping fo ... (cont.)

The attatched photo shows the stripping I need to replace. It inserts into the door frame with a plastic ridged strip that is 1/4 inch in width the the door closes onto the piece that looks like a J. One photo shows it in place and the other shows it in my hand I need 335 inches of this insertable ... (cont.)

I am adding photos of out bay window and weather stripping that is disintegrating. Also damage coming to woodwork inside. I have tried Home Depot and have been searching the internet for a similar stripping with no luck so far. We will use a water proof tape to seal it up for the winter. I need abo ... (cont.)

Hello, we have double hung wood windows by weather shield that were installed in 2006. I need weatherstripping to replace that in the photos. It fits in a groove on the bottom of the lower sash. The foam filled part is approximately 0.5", and the plastic insert is about 7/32" or 1/4". It looks a ... (cont.)

Hi. I'm looking to replace bubble seals on 20-year-old double-hung wooden windows. The bubble diameter of the old material is 1/4 in., and the base extension is also 1/4 in. (See photo.) I'm trying to get a tight seal on gaps that run along the bottom of the lower sash and top of the upper sash. ... (cont.)

The sides are a standard foam compression seal like 58-056E, but while the bottom is a similar shape, it is larger and a very thick vinyl. There is a very large gap in the door threshold to fill. Thanks!

Hello,looking for weather strip ,for french door. No any stickers just on a glass is GUARDIAN.Thanks

White soft plastic with hard black edge, 76 inches long, about 3/4 inch wide for JeldWen fiberglass exterior French door with blinds between glass. Also need weather stripping for base, black 69 1/2 inches long, 3/4 inches wide. Same shape, both have what appears to be foam filling. ... (cont.)

Looking to replace a atrium door weather strip

No markings visible on door, side glass, or any etchings in glass. Need to replace seals Photos included Thanks, Ed

weatherstripping for PGT 750 series French doors

Can you please identify my weather stripping? I need to order it from you for a standard exterior front door. ThanksDavid

I need to replace the door weatherseals on my doors. I have included photos. Do ypu have anything similar that would work as a replacement. The insert part is about 5/16, the v portion is 1/2 inch deep and wide. Foam filled. Thanks

We have a Milguard French door About 10 to 12 years old. The weather strip has worn through and needs to be replaced. Thanks for your help. Jim