Viewing all customer Discussions for:

82-086 Legacy Keyed Handle Set, 3-15/16" (1-1/8" to 2-1/2")

Need part to replace broken lock on door handle or entire handle assembly. Photos attached

I need a replacement mortise latch For this door. Can you please assist?

Sliding glass door with no identifying make and manufacturer located. 3 15/16" handle. Lock and latch stopped engaging. Can you help me locate either the proper lock mechanism to replace or a compatible handle set if it needs to be entirely replaced? Thank you

Our old handle broke off due to installer not raising lower on of the s Rollers. It was in our rental and they yanked on it till it fell off. It could only be latched from the inside so I'd like to add a keyed lock. I bought a replacement at a big box store but the latch amd key part we're centered ... (cont.)

Hi. I have American Craftsman 5500 series sliding doors. The interior handle snapped and the lock mechanism fell inside the door, so I need to replace both interior and exterior handles and lock mechanism. Can't find the parts anywhere!Thanks in advance for your help.Deirdre

I'm looking for a sliding door handle that locks from the outside to match the one I have. The handle is 8.5" by 1" and has a 4' gap between the screws

I believe I need a Jeld Wen dual latch keyed entry.

The Door is referred to as a ProFinish Brickmould 600. The distance between the two small holes is 3 7/8" (3 15/16"). The distance between the two center holes is 1.5". The small holes are 5/16" and the large holes are 1/2". I need a keyed locking system for the outside

Lock assembly DR05-1510

looking to replace hardware on sliding door please see attached phots.

There are no markings that I could find. the attachment screws are 3x15/16 apart. The base is 9x1/2 inches long but I don't think that matters. The door is 1x1/2 inches thick. Thanks

Good morning,Please find the attached pictures for my sister's glider. My name is David and I am a customer living in Clawson Michigan.I am hoping you can help me identify these parts. The entire locking mechanism is broken and will not lock. We have a wood kicker in place to lock the door. I can ta ... (cont.)

I'm wanting to swap out the door handle on my sliding door. There is already a latch in the door, the mounting screws of that seem to be of the 3.5" size. Do I have to purchase the mortice lock, since this isn't a new installation? I was going to use 82-086....that will fit my existing mounting hol ... (cont.)

Hello, I have a White Glass Sliding Door Handle with a key lock with the letters JW on the top. I need a handle replacement. I tried uploading a picture but the link won't respond. I checked my pop-up settings but they look normal. I have a picture to provide to help identify the product I need ... (cont.)

I need to replace the latch and key lock. Can you please help me to select the correct parts?

How to repair the lash level the lock bolt is not locking no more on my door

The lever is broken and the pin came off. I think I only need the latch washer and the pin. Why the pin only measures 7/8"? Is that the correct side?Do you delivery to Toronto Canada.Thank you, I appreciate your help.Otto

We need to replace the glass that has broken seals and the handle. It's a slider on a manufactured home. Patio Door Series 870 MFR - PHP-28 (Not sure who that is)

Hey Team, I believe I'm in need of a new lock but don't know where to look. Hopefully you can help me with my sliding door lock. Thanks much, Jonathan

Good afternoon. I have multiple sliders with number ALI ADW-8 ASTM 2190 ARG and am in need of a replacement handle for one of them. Without searching through the entire catalog of handles, I am hoping you can identify the correct one based on the pictures