Viewing all customer Discussions for:

32-039 Drawer Roller

I would like this part

Looking for a replacement for this roller. Any help is much appreciated.

Hello, I need a few replacement wheels like this, can you help point me to the correct part numbers or alternatives? Diameters are: 1 inch 3/4 inch Thanks.

i need replacement drawer rollers - 12 large ones and 12 small ones. they go in a (45-50 year old) 4 drawer office cabinet made by steelcase (i think). i have included measurements (using a digital caliper) of the rollers. they are similar to SWISCO item # 32-039. however, the item # 32-093 do ... (cont.)

I am looking to refurbish an old steel case desk. Do you carry these desk drawer rollers and securing pieces?

Do you have a roller as in the picture?

Looking for drawer sides with roller & bracket

Hello. The roller wheel on my pots pull out drawer broke. Here is photo of intact side. Do you have the whole piece that I need? Thank you.

Looking for replacement plastic rollers for metal cabinet drawers and want to be sure I order the correct item. Inside of roller is marked "W-LM. Co. Pat. Pend." Roller measures approximately 1" dia. x 1/4" thick . Thank you for any assistance

Roller dia 19 mm c 6 mm thick, And 12 mm dia x6mmthick

Steel Cabinets from 1972. Drawer wheels are plastic, possibly nylon, outside diameter 15/16 inches, Wheel rolling flat surface is 1/4 inch wide and offset from steel surface by 1/8 inch, mounted into a pop in hole, and hole diameter is approx 5/16 inches diameter. The wheel rotates on a plastic cen ... (cont.)

I am looking to replace roller brackets, guides and hinges on my Scheirich kitchen cabinets. Roller brackets have part # listed as 15000-7 & 8, roller guides are 15000-1 &2. Could not figure out part # for hinges. Can you help identify replacement parts? I have 7 drawers so need seven sets of right ... (cont.)

Need rollers for kitchen drawers

Drawer slide has an NL CO stamped on end.see photo.Slide is 21".From a Quakermaid cabinet. Probably 1968

I have an old metal cabinet with roller bearings in the drawer slides. The plastic or nylon wheel broke. It appears to be a rivet axle style so that it fits flush against the cabinet wall.Can you supply the proper bearing and rivet attachment?Thank you!Dan

The part is embossed with the designation Unigrass 6000. It physically makes one side of the kitchen drawer I'm repairing and integrates with the cabinet mounted rails. I need a replacement part due to the roller on one side of the drawer becoming detached. The part is 20" long and 3.25" wide. ... (cont.)

the plastic wheels at the ends of the rails are broken. Is there a way to replace just that paryt. if not, where to get the rail. Thanks p.s. pic is upside down, obviously alan

Any suggestions on replacing arrow metal shed plastic slides with drawer rollers/brackets from swisco?

Hello! One pic shows intact wheel, the other shows metal hub needing replacement wheel. Plastic wheel measures 1" in diameter, metal hub measures .5" in diameter. Will a replacement plastic wheel snap right on?