Viewing all customer Discussions for:

32-053 Drawer Track Kit

14 inches long fits on large draws hook into wooden track on dresser

I would like to make sure I am ordering the correct hardware for my drawer repair. Part of the glide is broken off. The furniture was made by Winners MFG in 2010. The Item No is B1045AN. I hope this provides enough information to give me a part number for my order.Thank you,Mario ... (cont.)

What supplies could I use to replace these parts they are the parts from the bottom of the dresser drawer.

Im having an issue finding a replacement for this. Do you have it ?

3.328.107

The runner on the bottom of the dresser drawer is broken near the back of the drawer (see close up shot). I'm attaching pictures of it on the drawer as well as the wooden piece on the dresser that it is supposed to fit on. I'm hoping you have a replacement! Let me know if you need more info. Thanks! ... (cont.)

Do you have the rod that connects to this part? I have a butcher block table drawer. With both ends but nothing in the middle.

looks like KENLIN CASE RUNNER except there is no wheel Product Code: 32-076

This is from a kitchen drawer. The part mounted in the cabinet is 23" long and the part mounted to the drawer bottom is 19.5" long.

Reached out to store - where furniture was bought, recommended this site; furniture made by Bassett, +/- 10 Years Old - Plastic drawer sliders broke - repeatedly, trying to find out if they are still available (or something better), and how much 15 of them would be. I also need the availability of ... (cont.)

Is the part #32-081 a direct replacement for the pictures below?

I have identified the following Kenlin parts that I will replace: Case Runner 32-076, Draw Socket 32-081. However, I have not been to identify the two track components shown in the photos, and they must be replaced. Please advise. Thanks in advance! Dave

I am looking for a replacement for this center mount drawer slide. The bottom slide (#1) measures 18 inches and mounts flat at the front and back of the drawer opening. The top slide attached to the drawer measures approximately 16.25 inches and mounts flat underneath the drawer at the front (#2)a ... (cont.)

Looking for a replacement slide for 2 drawers. Picture A is the bottom of the drawer where the slide is missing. Picture B is attached to.the dresser. The missing part should slide on to it. the length of the slide is 14in long. Please advise on the correct replacement part.

1960 under mount kitchen cabinet draw tracks

Looking for the track and fittings for a dresser drawer. Item detail in pictures. Made by Lea industries. Item #L711-241

Looks like number 168 on plastic, but really hard to make out.

I need to replace the 16 in dresser center slide (the ball bearing piece broke) The Dresser is from around 1992 (part of a Thomasville Bedroom Set). Please send a part number for the original slide or a replacement part.

Hi there! Looks a lot like the Kenlin case runner (product code 32-076), except that this one has a small roller/wheel in it to help the drawer glide back easier. The dimensions are the same as well. Thank you for checking on this for me. I appreciate your help. ? Marcia

Pics are of parts installed and uninstalled. Want to replace all -- front stop, drawer guide, and side guides on 15 drawers. Drawer has metal track (pic included)