Viewing all customer Discussions for:

39-439B Encore Dual Arm Operator, Sill Mount, Low Profile

Hi, do you have any similar parts? I can't take it off right now. I don't know if this is one part or a combination of parts. It's from a Simonton casement window from 2008. Thanks for any info you can provide.

Looking for a replacement operators both left and right hand positions for 2 late 90's Certainteed casement windows. I think you have what I need but could use some advice on picking the right ones. Please list the parts I would need to replace both entire assemblies. Thanks.

I'm going to need some parts to replace for my windows. Attached are some photos I have taken. Since these two windows are located close to the beach they are exposed to salt air and age a lot quicker than everywhere else. I don't need the cranks but I do need the arms and slide assemply to two wind ... (cont.)

Looking to buy the Truth window crank assembly including the handle. Is there anything else you require?

I need to replace the right and left hand operators shown in the pictures. The hardware say "Truth" on it. It appears they could be the Encore Dual Arm Operator, Sill Mount

Hello, I have two casement windows and they are the same. Very rusted and I would like to replace hardware. Do you have parts and is it a DYI (I watched a few vids).

I hope my photos will help you identify the correct replacement operator.

Arms, runners, all parts

I have no information on these windows and I'm in need of getting 4 replacement cranks

My hand crank opens the window, but unable to close the window. Replace the hand crank only, but that did not work

Labeled "TRUTH" back of crank assembly just has a manufacture date (?) 03/19/19 05:25 B and there is a letter D on the hinged arm. I found a nearly identical part online, but it didn't have the black plastic slide at the end of the long arm. This slide appears to be permanently attached with a non- ... (cont.)

I need 5 left hand cranks I I need 4 right hand cranks for Heard windows. sissor long post 9" short post 7"

Two cranks like this one shown in the picture need replacement. I have highlighted the one 'arm' has the number <32010> stamped on it and circled in the picture. This number is stamped on all of the cranks. Can you identify and provide replacement cranks for two windows? One crank is on the ... (cont.)

Hi, I need to replace the crank and catch on these windows to make them bronze. It says Truth on the hardware and i think they are hurd windows.

We need replacement parts for these Farley vinyl windows. Attached are what I was provided to send.

Hello. We just purchased a home with Hurd windows. We have several operators that no longer work. I have been searching for replacement parts, but have been unable to find / understand if a replacement parts will work. I do have pictures of the current hardware that I can share. I would like to ... (cont.)

I am in need of both the left hand and right hand window operators. I believe they are your part numbers 39-438B and 39-439B. Can you confirm. My measurements match your measurements included in your images of 39-438B and 39-439B. I have a round hole at the end of one of the arms. I can't tell ... (cont.)

These locking mechs and rolling armatures need replacing. Trying to identify correctly. Pretty sure it's a Swisco window.

hi I found a number on the arm ,it is 318-58 I couldnt getthe mechanism out from the window The Mechanism is a right handed for the right side of the window

Hello, I am looking to replace three total cranks. I am unsure of the brand but I believe it to be Pella as a smaller window in the bathroom of my home does have a model and serial number on it. this window opens right and the other two open left. thank you!