Viewing all customer Discussions for:

32-061 21-5/8" Self-Closing Drawer Slide Pair

Rear wheel roller for kitchen drawer

Hi! So the pictured plastic rear socket cracked in two places, the actual socket and the plastic pins that hold it into the back of the cabinet. I can't find this rear socket anywhere. Any help is appreciated!

Drawer guide rollers have the name GRANT stamped on the metal bracket as well as DL (drawer left) and DR (drawer right) on each corresponding bracket with 10/16" diameter nylon ball bearing flat edge wheel. I'm looking for 12 sets (24 wheels) for my mothers 1980 kitchen. I really only need new rolle ... (cont.)

I have a Mepla (label on the bracket back support) 543.000 55.02 are the identifying numbers on there. The bracket holds off the face frame in the front approx. 1" to 1-1/4, maybe 21" in length. 2 nylon wheels a set of small spikes that goes into the back of the drawer itself and screws in under the ... (cont.)

Need replacement for rear mounting bracket for glides; cabinetry installed back in 2006; probably discontinued by now;

Hampton Bay cabinet. The back mount which holds the drawer side rails has broken. The part fits in two holes in the back of the cabinet, and the "L" end of the side rail slides into the part.

this is for epoxy coated side mounted slides. it mounts into the 2 holes in the back of the cabinetW= 1 1/8L= 1 7/8slot for slice= 7/8pegs= 1 1/4 on center

I have some Houck 70CL 22 inch slides on my kitchen drawers, probably installed some 30 years ago. The back brackets are breaking. The current bracket is around 1 & 1/16 inch wide and about 1/2 inch deep. Would you have brackets that would fit these old slides?

I have a set of kitchen cabinets, utilizing the hanging drawer brackets, similar to your part 32-094 (Mine are about 1 inch deep and labeled 'left' and 'right') I am missing the left hand slide that attaches to the cabinet and hanging drawer bracket. I measured this bracket that is on the right ha ... (cont.)

I am trying to replace Unigrass 6600 550mm drawer slides\rollers. Will Product Code: 32-061 be a suitable replacement? Thanks, Kris

Hello, wondering if anyone can identify these and if they're still available? Thank you, David

Do you have this style slider drawer glide- 22 1/2??

Does the 32-018 work with the 32-061?

Unigrass 6600 slider and adjuster needed.

I found the part number for the Grass Adapter brackets, but I can not find the Draw Slides that I need.

no markings on any of the three pieces. The third piece is the one glued in the back of the cupboard that supports the stationery slide. These pieces do not attach to the wall. There is a space between the slide and the wall

Will these lock in place so drawer won?t slide out during travel

HelloI am Having difficulty finding the replacement bracket from my cabinets that were installed in 1995 it is a euro type the length is 2 1/2 inches and the width is 1 1/4 outside with in 1 1/8 inside width. Do you have this part? Thank you so much for your help.Dina

The slide is 20-3/4" long. I need a pair.

Hi all, could use an assist with this one. Need to replace a broken kitchen drawer mount. Slide opening is 1 1/8" Everything I've found is much smaller.