Viewing all customer Discussions for:

81-293 Patio Roller Assembly, 1-1/4" Dia.

Can you please identify the carriage and roller shown in the attached photo? I need two of them.

Hello I am looking for replacement glass door slider rollers the tag on the door says Marlin 6500 and then below that it says sgd-c20. Can you identify the parts and do you sell them?

Hi! I have an old mirrored sliding door on my bedroom closet and recently one of the ears broke off the roller bracket. The unit I took off looks exactly like the unit in your image above (877967?) Are these available anymore? Is there a substitute?

Hello, I have been trying to locate a replacement for the pictured door rollers. What seems to make this difficult are 2 things - 1) Roller wheel is 1 inch diameter and 2) It appears to be called an F tab where it attaches to the underneath of the door as apposed to the end. On one of the pictures y ... (cont.)

The needed roller assembly is for one of the three triple glass doors for a bedroom closet. Each glass door has two of these rollers (one on each side). The roller had a lot of thread binding it completely. After removing the thread, and cleaning it, the roller rotates but not as freely as the ot ... (cont.)

No id numbers all metal including roller 8-10 mm x approx 40mm approx 50 years old

This is 1 1/4" diameter. It appears to be much like 23-043; however, the tap for the screw is different. The tab on the one we need to replace has broken off.

do you have this wheel. i need about 50 thanks I HAVE A ACCOUNT . DISCOUNT GLASS SERVICE FRAMINGAHAM, MA. 01702

Hi I'm locking for roller closet door part # 136089 the wheel 7/8 "and the thickness 1/2"

Your roller is similar to my requirements but it is too wide. Please see attached diagram of what we require (metric measurements).

From circa 1995 Marlin Windows, in California. Marlin Windows has undergone ownership changes since then so they recommended I use your service. Thanks!

need replacement caster/roller/glide for closet doors. wheel is brass/copper colored 1 1/4 inches in diameter 5/16 wide. no marking/stamps/identifiers are found. Would need 6 items (replacements for 3 doors)

good afternoon. can you help me with these? if you need dimensions let me know. thanks

Hello, I'm looking to replace the wheel assembly. The door has been grinding along the bottom for some years now and if the door is salvageable I would to start with the cheapest way possible starting with the wheel assembly and tracks

Please identify the correct rollers I need to replace these. Width 5/8" height 1-1/8" wheel diameter 1-1/4" all metal wheels and frame.

These (photos attached) are the rollers I hope to replace. The flanges are .665" wide. 23-232S are too wide. Can you help me identify the correct rollers, please?

Please note the angle of the mounting screw, indicated by arrow in ..389 of the pix. This seems critical and has proven hard to find.

Hello, I'm in need of 2 new rollers for my aluminum sliding door. I was able to remove the wheels but have had no luck in replacing them and I hope you can help. The door is old, a little over 6 feet tall with a single sliding glass.The roller itself is approx. 1 3/8" tall (to the tang). 1/2" wide w ... (cont.)