Viewing all customer Discussions for:

90-180 Window Sash Lock, 2-1/4"

2 1/4 from hole center to hole center

ALPINE WINDOW LATCH 830000. NA2 2 1/4" BETWEEN HOLES 3/8 FROM TOP EDGE 2 7/8 WIDTH

Need window latch design below

I am looking for new latches that look exactly like item # 90-180 except with slightly different measurements. My latches have ,as seen in enclosed pics....2 1/16 × 7/16. Thank you.

Can you help me find these brackets for our Tractor sliding windows. They are about 12 years old. If the window is closed with the locking lever in the position shown it can break the tabs on the bracket. Thanks for your help. Space between screw holes is 2-1/4" space between screw hole and top edg ... (cont.)

This is 2inches long and 3/8 thick for tilt window lock catch. Thank you

Let me know if you have this window latch and the cost. Thank you.

I am looking for balancers 2930 2920 And 2910 Please help identify Thank you, Richard

Good afternoon,I'm looking for the replacement parts as attached, the width of part with locking mechanism measures 2 11/16".Thanks for your help!Jennifer

8206-00 is on the back of the latch

I need the window lock replacement for a lost one.

Do you have replacements for the attached photos? I tried looking though the website, but did not see an exact match. If these are unavailable or discontinued, do you have an alternate type that would work? I need 10 sets.

we recently had our interior house painted and the painters lost 4 of these... can you find a replacement?

Just purchased a townhome and looking to purchase replacement latches for my windows. Having a hard time finding the brown color but am open to using something else if brown is not available.

Original Window Vertical Sliding Window Window Latch. Holes are 2 1/8 apart and 3/8 from the edge. I can provide more exact measurements if needed. Die cats material.

Hello, I'm searching for a window sash lock and keeper. The lock installed is Alcan with screw holes 2 1/4 inches apart (photo atch). The tongue extends from the lock body 5/16". The lock ledge is 13/16" wide. The keeper ledge is 3/8" ( photo atch).I believe the keeper would look like Truth Wind ... (cont.)

need to replace locks on sliding windows

Hello, I would like to track down the plastic piece that has a single screw in the top channel of the window. I would also like to replace the window tension retainers that are spring loaded and the retainer clips that allow for the installation and removal. Please let me know what information you w ... (cont.)

I have two broken window sash locks that I cannot seem to find locally. The windows are 15-20 years old. I have attached a photo of one of the broken sash locks. Please help if you can.

Looking for a replacement part of the Sash Lock. The Keeper part is fine but please see orientation since it is not screwed into the window on the flat side. Hoping you can identify this since CARE-FREE do not have a site. I can find a similar parts but then I have to remove the Keeper and dril ... (cont.)