Viewing all customer Discussions for:

90-180 Window Sash Lock, 2-1/4"

Hello, I'm searching for a window sash lock and keeper. The lock installed is Alcan with screw holes 2 1/4 inches apart (photo atch). The tongue extends from the lock body 5/16". The lock ledge is 13/16" wide. The keeper ledge is 3/8" ( photo atch).I believe the keeper would look like Truth Wind ... (cont.)

need to replace locks on sliding windows

Hello, I would like to track down the plastic piece that has a single screw in the top channel of the window. I would also like to replace the window tension retainers that are spring loaded and the retainer clips that allow for the installation and removal. Please let me know what information you w ... (cont.)

I have two broken window sash locks that I cannot seem to find locally. The windows are 15-20 years old. I have attached a photo of one of the broken sash locks. Please help if you can.

Looking for a replacement part of the Sash Lock. The Keeper part is fine but please see orientation since it is not screwed into the window on the flat side. Hoping you can identify this since CARE-FREE do not have a site. I can find a similar parts but then I have to remove the Keeper and dril ... (cont.)

I have 7 windows that I would like to replace the balancers and locks please How do I go about picking out the right parts please I have in two windows with 3/8 balances with 27" length Could really use some help please

Hello - I think I need a 90-180. However I wanted to double check. The two holes are ofset 3/8" from the edge and 2 1/4" apart. See attached pictures. Looks like the part # might be 8303 from Alpine. Thanks

Screws are 2-1/4" apart. Broken one on different window Thanks

I gave you a picture of the sticker from the window. I need 4 sets in white.THank you .Donna

Trying to identify proper sash lock replacements. Screws are approximately 2 1/4 inches apart

I need window locks for my windows most are missing there sideways sliding

good day i'm looking for a replacement for a traco lock . mounting holes are 2 1/4 inches apart. thank you

I found ones for single hung but not ones with this size 2-1/4 holes

Looking for this part for a PGT vinyl window.

On 10/24/22 order # 1969608 I ordered 10 90-183 sash keepers according to the measurements shown on line. The measurement not shown on line is what I am calling the bridge measurement. The bridge measurement on the broken sash keeper is 1 1/4", the bridge measurement on the 10-183 is 1 3/4" Please h ... (cont.)

I need to replace both the right- and left-hand tilt latches on an old vinyl window. Photos show what I'm working with. The dimensions of the 26-111 item seem to be a match. I've attached photos - does this look like a match to you? I will need the latch and the sash release levers. The 26-119 lev ... (cont.)

I'm trying to track down this part and I need 4 of them. Do you carry these or something that would work?

I attached some photos sliding window lock pacific industries 2 5/8" long 1" wide

The color doesn't matter. They were installed on double hung spiral balances aluminum framed windows maybe in the 90s. They look to be dicast metal brown paint maybe they were bronze in advertisement the center holes work with similar 2.25 inch sash locks but there is no maker mark patent pending is ... (cont.)

I bought a pair of S385-24 balances, along with a 90-180 sash lock.The double photo shows the new balance and obviously the clip didn't hold the balance as I raised the window up.What I did, is as follows:I removed the window sash as per the instructions on your video. I did not have to remote the o ... (cont.)