Viewing all customer Discussions for:

90-180 Window Sash Lock, 2-1/4"

Hello! No identifying marking on windows but many need replacements Sash is metal 3 inches long, about 2 & 5/16 hole to hole. Tilt lock is plastic , 3 inches 3/16 long, 2 3/16 hole to hole .

Attached are some photos from my vinyl Silver Line windows. I am looking for the correct parts to replace these with. I need the bottom hinge and a latch. I also included a picture of the one window as a reference. Please let me know if you need any additional information. Thanks Andy ... (cont.)

I purchased the wrong window locks for my Climate Guard windows and need some guidance. They are 2 1/4 spacing and the mating lock bar is "deep" and not surface mounted.

I'm looking for replacement window latches, "Care-Free" is cast into the existing latch. The window is a horizontal sliding window, with the keeper mounted 90 degrees to the latch, so the keeper needs to have the "cut-away" for the latch to rotate and engage. The screws are 2 1/4 inches apart. I've ... (cont.)

Vinyl window need lock 2 1/4 hole to hole.

I am trying to find replacement parts for the window latch and lock pictured. I cannot find markings on either the parts or the windows. The windows are at least 20 years old.

I have 3 pieces to order replacement parts for. I need 6 white locks. 4 white clips and 20 grips or handles Are you able to identify the parts from the pictures?

Hello: Please help me identify the correct part numbers for the Windows lock and pivot bar so I can make the purchase from your website. Thank you

One of my sweep latches has a broken spring and needs replacing. The screw offsets are 2 1/4" with a 3/8" backset. The keeper is 1.424" x 1.628" with 3 mounting holes (only two used). There is a part # on the keeper, #677147. Your part #90-180 looks close, but I can't tell if the cam will fit the ke ... (cont.)

I have aluminum single hung windows with Alcan hardware. The 90-009 latch (white) is a good replacement for my latch and I can pair it with your 90-109 keeper but I do not see a compatible keeper offered in white. Can the 90-282 (white) be surface mounted on the upper sash to mate with the 90-009 or ... (cont.)

This is the latch from my Gorell DH window. The cam plate has broken free of the operating/locking stem. Would like to order a couple of these.

I need 8 of these

Need the locking assembly

Do you have any of these? - 2 1/4" between screws - 3/4" from window edge to each screw

I am trying to purchase replacement locks for my windows, but cannot locate a direct replacement so far.Please find attached photos to see if you can help. There are no markings on the fittings that I can find. Thank you.

2 1/4" between centers of mounting screws 3/8" to screw centers from latch side

Please determine which window latches I need from your inventory thank you Joe

I need to replace most of the part you slide to tilt. Also the part that locks and unlocks. I need 18 of the slide part and 4 of the unlock part

My sash lock looks like your 90-180 (2 1/4"), but it is 2 3/4" on the outside and 2 5/8" on the inside (looking from inside the window). Centerline of Screws are 2" apart. Do you have this latch?

I was able to identify the snap-in glazing (55-092) for my old ALCAN windows, but I haven't been able to narrow down the replacement locking mechanism. Can you help?