Viewing all customer Discussions for:

26-471 Top Tilt Latch Pair

I need to buy a pair of tilt latches for a Ply Gem vinyl window. See the photos. Can you let me know I need to purchase? Thanks

I need help finding these latch replacements.

20 qty

I need a tilt lock for a Ply Gem window right side in a beige color. The one on the window isn't holding the window securely.

I am wanting to confirm before I order, but based on my first and second picture and taking measurements (1-1/4") of my T-lock balance shoe I believe your matching part would be 15-195. I think my third picture of the tilt window latch (2-5/8") matches part 26-419. Please confirm. Thanks! ... (cont.)

PAT NO 5,671,958 Spring loaded window tilt latch. 2 5/8" x 11/16" spring loaded

I have a broken window balance and I'm trying to find a replacement. I took pictures of all the pieces I know are relevant but let me know if you need anything else. It says 39D on the side and I think its a closed cam(pic attached) 1 1/4" . It also uses a clip to slide into a squarish hole(att ... (cont.)

I'm trying to identify the right tilt latches to replace the broken ones I have. The one I have is approximately 2 5/8 of inch long and 11/16 of inch wide. The thickness is 3/8 at the widest part.

I have windows manufactured by Builders First Source, they are series 9910. A balance broke and shattered the tilt latch on that side when it broke. I have parts to fix the balance but have never had to replace a tilt latch before and was looking for some help in determining the correct replacement. ... (cont.)

Do you have a replacement for this part? 2 5/8 " long 3/4 " wide Almond/Beige color

I need to replace a window tilt latch. Your #26-471 (pr) looks like the correct one and the length & width match. While it appears my tilt is a snap in - only the very top of it sits atop the window (considered flush?) - I'm not sure how to remove it and install a new one. Can you advise how to r ... (cont.)

Could you please help me identify the following double hung window latch. Thanks. David

Latch tilt part ID help. Looking for equivalent. This is the right right looking out the window.

I need a window tilt latch. Below is a picture of the latch. I would like to purchase 2 of these so I will have a spare.

Here are the rough dimensions Body is 2 5/8 Total length 3 inches Width 3/4 Thickness about 3/8

Can you please tell me if I can order this type of Top Tilt Latch for an Alenco window. The windows on my house are about 26 years old. Note these have two screws that hold them on. Can you please help? Thanks.Ben

I need help ordering the correct parts. Window manf. is unknown. Length of channel is 27 inches. 27B is stamped on the channel, as is smaller letter PR, followed by larger letters BSI.

need right and left top latch for a ply gem window. Add photo

We are looking to replace a few tilt window latches that measure 2 11/16" x 5/8" (see attached picture. We also need weather stripping. See attached picture. Do you have any recommendations? These are Simonton windows that are 22 years old.

This latch broke and I need a new one. It came off a PlyGem window from a ten year old house. There was only one sticker I could find in the window frame, which where I could make out the name PlyGem. Not sure if that helps at all. Thank you for your assistance. I look forward to fixing this window ... (cont.)