Viewing all customer Discussions for:

39-026 Awning Window Crank Operator

Just moved in. I lubricated what I could but a couple of the operators are shot. No markings at all. Gear teeth look worn and worn gear is loose and worn. Need white. Also need shoulder bushings.

Need 2 of these.

Good Morning,My name is Kenya. I need to replace a operator for my awning window but I am unsure as to which part to order. I'm asking for your assistance in identifying the model that I need.Measurements:Base (screw to screw) = 6"Depth (starting at base) = 2 1/4" approx.Width = 3/4"I have attache ... (cont.)

Need 6 cranks

Top to bottom from center of screw holes 5-1/4". Length of moving arm from screw hole to screw hole 2-3/8". Overall length of arm is 3". Distance between side by side screw holes at bottom of housin 1-3/8". Approximate age of installation is mid 1960s to early 1970s. Bushing on arm. Right hand ope ... (cont.)

I need to replace it. I'm clueless about measurements, etc. I had ordered a replacement from Amazon, but when it got here I noticed that it had two holes at the top of it and the one in the picture only has one hole at the top. I had to return it. I'm asking my son to install it since I am in my ... (cont.)

Need a new 1 cant find any part numbers anywhere

2 R.H. Patent # D-198.202 US RD 1963 can.

Unfortunately the hole is larger on the operator link than my original screw. I cannot tie on tightly. By the way the holes are the same size on the operator link and the window torque bar. What should I do, I don't want to send the crankers back they fit perfectly, please help, Thanks in advance Am ... (cont.)

The window is not secure to the frame. I think the retaining clips are not holding. Also can not find the correct replacement operator to wind out the window for replacement.

The gear seems to be worn out. Note the curve in the drive lever, unlike the one I bought which gets in its own way when closing. Mounting screws - 5-1/4, & 1-1/8, lever centers - 2-3/8"

There are no markings I can find. This may be similar to a Keller 39-061 but slightly different. Here are the dimensions:Top to bottom mounting screw (center-center): 5 1/4"Left to right mounting screw on bottom (center-center): 1 1/8"final link center-center: 2 3/16"The connecting hole & t ... (cont.)

Is there a generic window crank because I see a lot of cranks for specific window manufacturers

Hello, I will need parts for these awning windows. They were installed in 1967 in Massachusetts. The windows have absolutely no markings or any idication of the manufacturer. Thank you. Paul Wheaton

HelloI am looking for a window clip and screw part along with a crank handle for the window - this os a "sun room " from the 70's . I semt pictured above . Thank youVivian

Hello!I have 13 right and 2 left operators I would like to replace in a home in southwest Florida. The patent number D 198202 was found embossed in the metal cover. Could you please identify these parts for me so I may completely replace all?Thanks for your support,Wayne.

There are no names or numbers on any of the crank parts.

From what I can tell, the measurements you give for the 39-012 are essentially the same as my operator that died. My concern is the connection of the operator arm to the awning window movement system: In my case there was a screw assembly shown in pictures which had a female internal threads (and s ... (cont.)

Looking to replace an Awning Operator - Copied the parts I used prevuously from a different company