Viewing all customer Discussions for:

39-032 EntryGard Dual Arm Operator

This is a circa year 2000 Windowmaster purchased from Home Depot and installed by my contractor. Looking from the inside, the crank is on the left and the window pivots out opening on the right. The part reads Entrygard and on the bottom there is a code 40754

The window crank for the right hinged window is broken, window cannot be opened anymore. The other image shows the opened opposite left-hinged crank as an example. The smaller crank arm has the number 20810 imprinted on it. The cranks are found on Crestline Casement windows.

I haven't removed them yet as I'm afraid to without having a part to replace them. This one says Lincoln and it's 4.5" wide at the narrowest and maybe 5" wide at the widest. Not sure as I didn't take it off the window. Also says "made in the USA."

Good morning, I'm looking for the following replacement parts for my existing Semco casement windows (vintage approximately 2002):1 - operator mechanism, see attached 3 pictures showing arm lengths and orientation 1- handle for mechanism (bronze)2 - operator covers (bronze)1 - latch (right hand side ... (cont.)

30472 RH us the number on the big arm on little arm two numbers for the 2 parts of it 2810 and R30842 the base has number 40572

These were Peachtree windows that were put in about 35 years ago. As you can see from the photos it opens out to the left. The number on the mechanism is 2081. And the wrds on the mechanism are Entry Gard TRUTH

Hello. We have 2 clad case master Marvin windows. The cranks (part number 10898240 ) no longer work. They are discontinued. There may also be a problem with the operator too. When the cranks did work, we could get the window to open. However, to close the window you'd have to lean on it from the out ... (cont.)

It is stamped Truth Entry Guard, and has gears similar to 39-036, but the operator's arms and link arms look different.

I WAS WONDERING IF YOUR 39-032 (?) IS THE CORRECT REPLACEMENT CRANK. THANK YOU, DON

I am needing the crank replacement for our window. I am not sure of the exact part numbers. The widows were installed in 1994 by Milguard. Please let me know if you can help me with this or if I will have to get more info, and if so what exactly, in order to know the part for sure. ... (cont.)

I am in need of a new window crank. On the handle it says KK so I'm hoping you can help.

Looking to match and order these. Any suggestions would be helpful

This broke over the weekend. It will allow the window to open, but will not close the window. The entire case pulled out, and is broken where the handle pushes in. Thank you so much.

Hi there, What model do I need to replace this casement operator?

Hello- I'm looking to replace these two operators. The left side has markings 20544 and 30744. The long arm is 9.5" and the short arm is 4.375. The right side has markings 20810 and 40841L. Same arms lengths as above. Thank you!

The word "truth" is seen on the bottom right of this split arm operator

Looking for a replacement window mechanism, Dashwood window with Truth hardware, short arm #20755, 30841L

I am trying to find the casement window hinge with a number of 31538A

Need your help identifying and ordering both left & right sides for this window

looking for a replacement part for cranks with a label of 20810 as well as 6092 can you tell me what part i will need to replace the whole mechanism? Thanks