Viewing all customer Discussions for:

39-035 Truth Hardware Entrygard Dyad Window Operator

Hello, two of my windows have broken cranks, as shown in the pictures. On one the inner mechanism (removed) looks damaged and won't fit back in and I'm able to use the crank handle to open the window (with difficulty) but it won't close it. On the second window, the inner mechanism and the operator ... (cont.)

I have a truth brand operator from 1982 and need a replacement. See pictures of engraved numbers and measurements. First arm measures 4 3/8 Second arm measures 3 13/16

Looking to purchase two Pozzi Window Casement Cranks...one for a window on the right side and one for a window on the left side. Do you have them available or know where I can buy them??

Tom

Please help me identify replacements for this hardware. Thanks

Large dual arms 7in and 10in (other dual arm operator is slightly smaller) Othe cranks are 10in and 4 inch.

The parts are labeled Truth EntryGard 30751-B. Do I need to replace everything? Or is it sufficient to replace the crank assembly, and attach it to the sliding parts attached to the window?

Hi! Need hel in identifying this

This particular unit does not have any name on it, but the window has four operators. Two on the left side of the window and two on the right side of the window.

The Arma that ataches to the window is aprox 4 and 3/8s

Parts information: This window is roughly 14" wide and was installed around 1994. The handle has 40085 and 24 printed on it. The window operator has Pat.No. 4,840,075, Made in the USA, and TRUTH printed on it. Problem: The handle and the metal shaft from the window operator slowly spin out of the ... (cont.)

Hi. I have 2 70" tall x 27" wide casement windows with operators like the first 2 pics and then 2 that are 31" r tall by 16" wide and their operators are like the second 2 pics. Can you tell me which operators to order? I need a L/R pair for each set of windows. Thanks VERY much! ... (cont.)

The above pictured Truth mechanism on my Marvin Bay window (left looking out from inside) casement has stopped working. I believe the Marvin serial number is 01 1G 00 OBA IGMAC, however, I'm not sure if the 00 are CC because it's really hard to see.

Hi ! I need to replace some broken and stripped operators but I am not sure of the part#. Could you point me in the right direction?

Here are a few new pictures. Model ? 3084IL or 3094IL and 20810?

I can't read the final letters/numbers on the assembly due to rust. I think it is ZO. Those last two appear to be letters as they were thicker than the numbers. We have not removed the assembly so I don't have a picture of that but we did take off the "cap" hiding the mechanism and I've sent a pi ... (cont.)

Hello All. I am looking for the below part. On the left control arm, there is a stamped number:5084L Thank you for your reply.

What type of hardware do I need to replace this?

Pat no. 4.840.075 There is a number 45275 on the frame 31782L on the gear Says EntryGard by Truth

This appears to be a TRUTH EntryGard casement operator. From the picture, you can see it is stamped 45275. It has two arms, but, unlike any of the EntryGard operators I've found on the internet, one of the arms on this one (the arm which goes in the rail), is short and is attached near the hinge edg ... (cont.)