Viewing all customer Discussions for:

39-035 Truth Hardware Entrygard Dyad Window Operator

The above pictured Truth mechanism on my Marvin Bay window (left looking out from inside) casement has stopped working. I believe the Marvin serial number is 01 1G 00 OBA IGMAC, however, I'm not sure if the 00 are CC because it's really hard to see.

Hi ! I need to replace some broken and stripped operators but I am not sure of the part#. Could you point me in the right direction?

Here are a few new pictures. Model ? 3084IL or 3094IL and 20810?

I can't read the final letters/numbers on the assembly due to rust. I think it is ZO. Those last two appear to be letters as they were thicker than the numbers. We have not removed the assembly so I don't have a picture of that but we did take off the "cap" hiding the mechanism and I've sent a pi ... (cont.)

Hello All. I am looking for the below part. On the left control arm, there is a stamped number:5084L Thank you for your reply.

What type of hardware do I need to replace this?

Pat no. 4.840.075 There is a number 45275 on the frame 31782L on the gear Says EntryGard by Truth

This appears to be a TRUTH EntryGard casement operator. From the picture, you can see it is stamped 45275. It has two arms, but, unlike any of the EntryGard operators I've found on the internet, one of the arms on this one (the arm which goes in the rail), is short and is attached near the hinge edg ... (cont.)

Hello, Our window operator gear sheared off. We need to replace it, but not sure of the model. The brand of the current one is Truth. Thanks, Jason

Stamped on the assembly is "Truth" / Pat no. 4,840,075/ Made in USA. Also on one cogwheel is the number 3136 although I am not sure of the last digit. The house was built in 1996. Thank you for your help

Looking to replace window latch

Hello, I think I made a mistake in ordering a replacement part. The one I received is not the same as the one in the picture above. Can someone please help me order the correct replacement assembly>

I am looking for this part. Your suggested replacement part is 39-031, but that part has a nylon wheel and mine has a metal disk. I believe the nylon wheel on your part, will not fit my track. On the back,on my the long arm, the #40753 EntryGard Truth is stamped. On the back of the shorter arm th ... (cont.)

I was going to order these but wanted to know if they were the correct parts for my kitchen window. The gears shredded and crank handle just spins. Thanks! LEFT SIDE https://www.swisco.com/Dyad-Window-Crank-4-inch/pd/Casement-Window-Replacement-Operators/39-036 RIGHT SIDE https://www.swisco.com/Dy ... (cont.)

This is the window handle that allows the window to be opened.We require 4 if you can assist.I do not have a photo of it unassembled unfortunately.Thank you for your help.Jennifer

Part with groves on crank is loose, cannot operate window. Is there a replacement operator? Thank you,Audrey

I need replacement window hardware. Please see attached photos and let me know which items are compatible. I'll need the replacement for a left and a right crank window. ThanksJerry

Looking these parts =)

Hi,I would like to get a new operator. The numbers on the operator don't seem to corollate to anything. Any help would be apricated.Thank you,Mark

Hi Swisco- I'm looking for 2 styles of Truth operators from the 90's. What makes them unique is that they they have a mounting base that is only 1 1/4" deep rather than the current entrygards that are over 2" deep. I will attempt to attach a couple of photos. I need left and right straight arms an ... (cont.)