Viewing all customer Discussions for:

39-070 Lever Lock Awning Window Operator, 23-1/4"

LOOKING TO REPLACE BROKEN HANDLE

I have a couple handles broken and looking to get a couple replacements.

I am seeking replacement handles for a few transom-type windows (? terminology?), that are hinged on the top and open with a side-swing of the handle as shown in the picture. The logo says "Vistarama Windows" and the house was built in the 1960's so I am guessing that they are from that era. If you ... (cont.)

Anderson windows from 1968. Need new handles for windows.

After painting the house exterior, the windows were sticking on opening. One of the opening handles (of two windows side by side) sheared. Assuming that's aluminum. Trying to find a replacement of the part(s) needed.

I need to replace Window awning dual arm operator. 22-1/8" with arms flat against the lever plate. the cross piece between the arms is 10-3/8". The Handle portion is 3-1/2"at widest then cuts back t 3" Leaving a 1 inch space for mounting to piece of the side frame of window. x 4" Deep from handl ... (cont.)

Hi, How do I measure the lever-awning operator to figure out the correct size to order? I think we have an older 39-070 type operator. Ours doesn't have the lock and the pivot point it visible. The pivot pin is worn out and therefore the window opens and closes poorly.

Looking for a replacement lock for the window pictured. Window 3 - the broken lock/lactch. Window 2 - what the unbroken one looks like. Window 4 - the window sash bracket. Thank you!

Can you help to identify the hinge and operator hardware in the attached photos? It appears that the hinges could be sprung because the gap between the window and jamb on the left side(outdoor view) is about 1/4" and the right side is up against the jamb. The opening hardware is operating properl ... (cont.)

I've read that a replacement window mechanism is required. You have some labeled as 20 1/4" and 23 1/4" models. What, exactly is being measured?

Looking for a replacement part for a Alcan window closing mechanism. This one works but does not close the window tight and correctly. See photo for the part that I need to replace.

Can we purchase the handle assembly for the Awning Window Lever ? Our home was built 35 or so years ago and before we take the steps and replace all our windows we would like to repair what we have. Thank you.

Hello. We have the same issue (3) broken handles. Do you measure the arms as close as possible in the retract position? I measured at 22 1/2 inches.

Dashwood window , Truth marking on handle

Is it possible to get this part?

The handle broke off of my window crank. When you pull it, it should open the window and when you push it back, it should close. Do you have this part? I think I would need to replace the whole mechanism on the inside of the window.

Worn out I need to replace 5 of them. House was built in 1966. Could be corado? Windows. Could not find any identifying markings

Trying to locate this part, handle broke from the window track.

First image is one of the good condition handles in the open position. Second image shows a handle that sheared when using due to the window sticking along the framing. Looking for a replacement part and install instructions. Thanks

Photos per previous email