Viewing all customer Discussions for:

39-070 Lever Lock Awning Window Operator, 23-1/4"

This is a non folding handle...broken off after the hinge part...do you have replacement? If not, is there something that would work to replace the whole opening mechanism? Thank you.

I need to replace this part for my window. I cannot find a part number on it so I am not sure it is even an Andersen part. Do you have anything thatmight work? It is all hide under the window sill when done. My home was built in 1965.

Do have these or know where we can obtain them and who manufactured it we need 2 Thanks

Good Morning We are looking for replacement hardware for an old awning window approximately 30 years old. We ordered your 39-070 but the housing is not as deep as the old one .. The replacement is approximately 1-1/4

Hi Is item 39-070 right or left handed? I need this item to be the same handing as in the the photo on your site. thanks, tina

Are these still available?

What is the procedure to replace this type of operator. Does the cover pry off, or do you remove the wood piece around the lever on the inside?

I removed the operator from the window. Your part number 39-070 appears to match very close. My dimension is close but not exact on the 23 1/4. I measure 23 and presume that this should operate ok. Unless I hear differently from you, I will proceed with the order.

How do I adjust lever lock awning window hardware to prevent cold air from coming in?

I am trying to replace the handle for a Pozzi Awning Window. Do you have this part?

Hi - i bought a lever operator last summer and replaced the old one myself. The awning window is quite big - over 40' wide - and the sash hook seems quite small. With the window closed, the lever pulls the window tight to the frame where the sash hook sits but on either end, it does not seal tightly ... (cont.)

I am needing to find a replacement handle for my Pozzi casement window.Below are some pictures of broken handle.Thank you

Hello, I am looking for new hardware to replace the current hardware on my horizontally installed Andersen casement windows (they open out from the bottom by pushing the swing arm). I have 12 in total and would like to install some sort of replacement hardware that functions differently (like a cran ... (cont.)