Viewing all customer Discussions for:

Door & Window

Hello, Please provide a match for these if possible.

Window lock levers and bar. Traco 1990 Truth 40068 operator

I have a block and tackle sash balance for a tilt window. The code on the existing balance is 28E BSIAO. The balance shoe looks like a SWISCO 15-194. Do you carry a replacement balance? The hook goes into a round hole. I'll need two, if they can be made with the 15-194 shoe

30"channel balance number stamped on balance is 30B BSI PA

Hi, I have a very large sliding glass door with this handle on it. I am guessing handle is from 1960's. It has a lucite handle, which has broken at the mounts. Cast in the lock level is "Ador" and no other part/identifying numbers. I would like to either find a replacement lucite handle (could ... (cont.)

I have a sliding door handle that I need to replace but cannot identify the manufacturer. It is stamped "Made in New Zealand". The screw posts on the interior base and one on the handle have sheered off making the handle loose. Please contact me if you need additional information. Thanks! ... (cont.)

here are pics can you help

Hello there, we have pivot windows that we recently cleaned by pivoting out and now the window is hard to open/close and feels loose in the window frame. I believe that the shoes are worn and need to be replaced but i cant identify the brand of the windows or any shoes that look similar. See attache ... (cont.)

Hello, I'm struggling to work out which Andersen sash balance is the correct replacement for one of my windows. The right side (viewing from inside) is stamped "L1623/34" and also "P98 700". The other balance on the left side is stamped differently: "R1631/23" and also "P98 700". The main body ... (cont.)

2 part glazing bead part aluminum and part vinyl.the aluminum snaps into the vinyl. the vinyl snaps into the pocket of the window. never seen before.

Good morning, I am looking for replacement window balance coils for 2011 double sash Jeld Wen windows. I have attached a couple pictures to show the type of shoe that is used with the coil, but have not taken the coil off the frame at this stage. The sash weights about 19 lbs. Would you be able ... (cont.)

I NEED 2 PIECES 3240# 33 INCHES METAL LENGTH

spiral balances are 35"length, 3/8" diameter, and green tipped quantity needed--4slides are .365 thick, .965 wide, 2.030 in length quantity needed -- 4and a spiral balance tool (not deluxe) quantity -- 1Stuart

Hi, I purchased a home and am not sure who the window screen manufacturer is. I need to buy replacement corners for some frames I'm replacing the screens on. Can you help me identify which SwissCo replacement part would work for me? I am 95% sure these are 3/4 x 7/16.Thank you Edward ... (cont.)

At the bottom section of the window there's a pivot piece (the window can swing inside the home). This part is broken. It appears to be rod, that runs from on side of the frame to the other, but hard to tell exactly. The windows do not latch to the bottom of the frame and it causes the bottom of the ... (cont.)

Looking for replay hardware for maxx shower door 00004318251

Milgard window 31.7pounds, 31 5 stamp, I believe it is 1/2 inch width, non-tilt window. Thank you in advance!

The cast latches for the sliding window are broken. I'm wondering if the latches that you have will fit this door.Dean

Hello, Could you tell from your experience what kind of coil do I need to fix my window? Thank you! Eric

I WAS WONDERING IF YOUR 39-032 (?) IS THE CORRECT REPLACEMENT CRANK. THANK YOU, DON