Viewing all customer Discussions for:

Door & Window

Hello, I am looking for the highlighted piece in the picture I submitted. I believe its called a glaze beam?This is for a single hung window and the size it close to 1/2 inch.They seem to clip on and are vinyl I have a few around the house that are cracked and broken and have been trying to find the ... (cont.)

Hello- Looking to replace a non-keyed, non-latched silver sliding door handle. Thank you! ?

Armaclad windows need slides and balancers

I need to replace this balance, I believe it's a S170 - it measures 3/4" wide but the stamp says "10 J" can you help me with this?

I need the red bearing 5/8 diameter 29" long tube tension spring assembly.

Have Jeldwen door never installed with numbers G0313616334473 Trying to find handle set for it please with internal parts Don't know if it will work but bought Andersen l trim set 2578915 Please advise thanks!

there are no significant markings on this part

Store front door pivots

I do not see a design to match existing equip.

The black glide in the upper portion of the photo is showing wear. What is the part number to replace the section that it is attached to?

Hello - I'm considering purchasing "SS Patio Door Tandem Roller, 1-1/2" Concave Product Code: 81-182" I purchased Primeline part like the above, however the housing is too wimpy, it isn't strong enough. The stainless steel part attached has a stronger housing, but I need the tabs to be like the zi ... (cont.)

Double hung vinyl windows were installed in 2008 and no identifying labels have been found. I'm looking for left & right tilt latches for top and bottom sashes. Do you have anything that will work?

Hi, can I use this SS hinge set to replace the old one. thanks Dave

Hello, Attached is the picture of the interior door handle that broke. The measurement between the 2 screws are 4inches. Screw hole distance is approximately 3 15/16

Attached is two photos let me know if you have window balance for my window. Thank you

I am looking to purchase two replacement rollers. About 1 - 1/2 inch high, 3/4 wide and 2 -3/8 long.Thank you, Robert

Hi, I'm looking for a replacement part. the measurement from screw to screw is 5" but the arm is 4 and 3/8th ( or 4" from the center of the holes in the arm) Do you have a replacement part like this. All the other parts listed on your website list a 5" arm

Hello, Looking to see if you have a replacement for this.

Looking for replacement block and tackle for vinyl tilt window

The measurement from metal to metal is 33" The spring length is 21" The pulley length is 10" The shoe depth is 1" The sash weight is about 30lbs Will one of the series 380 channel balances work for me?