Viewing all customer Discussions for:

Door & Window

These are old ( circa1986) windows from my mom's sunroom. The plastic plug as you can see from the pictures has deteriorated and I would like to replace... is that something you have? Thanks for your help.

Custom balance

Semco Window was installed in 2002. Crank is on the right side when looking out. Appears to have a single straight arm about 9 inches long. Actual part has "Truth" name on the arm. Also need a white or beige crank handle.

Hardware needed for my two swing out windows as shown in the images below. The measurement of each "Operator" is ... 3 1/2" Wide and 1/2" High. I need new "Operators" with Handles.I can't use the handles due to possible worn male gear pin on the Operator. Or perhaps it's the far more worn internal g ... (cont.)

Hi, do you have any replacement kit for this type of roller? It's quite hard to find as this is a sliding door from the 80s.

Looking for full crank mechanism with arms.

Need to replace 2 sash for a single hung window and the broken clip on the window it self

Where do they stamp the weight for the coil balance spring? Is that what the 3 stands for? 3lb?

I need help identifying the correct balance. Please help so I order the correct one.

I am looking for replacement parts for the white "brackets" on the side of my Milgard casement window. Most of them have broken into half over time.

Hi- This lock is on a single hung vertical window. It won't latch properly. Can you suggest parts - I would like to replace it all. The brand on the latch is Jeld-Wen. The brand on the underside of the latch is Interlock.Thanks so much-Amy

Need to replace the spring pieces that hold the window in place. See photo. Do you have this?

I was referred here from Jeld-Wen support. They have discontinued the Mag-Lock window lock. I've included two pictures of the broken lock and two pictures with measurements of an un-broken lock. I'm hoping you have a replacement. Thank you!

Miss/Sir, I need to replace two of these operators which are installed on the right hand side of the window if you are inside the house looking outside. I hope the rulers give you the needed dimensions, please let me know if you need more information. Thank you.

I'm looking for some weep hole covers for some older double slide windows

My window crack broke off. Do you happen to have one or two? Can I send send photos to an email address? I haven't mastered how to send photo

I want to replace the crank and cover on my Amerimax Casement windows with folding handles and covers. The item I think would work is the Encore Truth Folding Handle with Cover, part #39-375 (right crank) and #39-376 (left crank) but I would like your advice. Attached are pictured of the Amerimax ... (cont.)

Looking for any help identifying the replacement part in the above images. These are on each side of the window and help it stay in place when open. Images show the broken pieces as well as a normal window. Part is attached with 2 screens into the bottom of the window. No brand name anywhere on wi ... (cont.)

Hi! I am looking for a replacement for a caldwell channel balance marked 18 4 DK. Can you help with this? Thanks,Terry

K/K brand. Need one for right swing window and one for left swing window.