Viewing all customer Discussions for:

Door & Window

Stripped head for crank arm. Need to replace it or the assembly. Thanks

Metal channel length: 25 5/8 Stamp: 25 5 BSI PC Manufacturer: unknown Count needed: 2 Also need: - part 16-035A (10) - also nylon part inside top of pane channel shown in attached picture. It measures 2 1/4" long, 5/8" wide, the top inside portion is 3/4" long with a notch.

I have these for a guardian screen window that I need replaced for ansi z97.2004 also says sgcc 2020 1/8 ua then says 16 that might be an I though cfr 1201ii I believe I did get the other parts correct that I needed but these I have no idea what would replace the these old swivels please help. ... (cont.)

I need to replace the roller wheels at the rear of the door and the lock mechanism.

Hello I need this part for tilt in windows, both are cracked and window won't stay up.

Hello, I am looking for a replacement handle to fit a NAMI sliding door 4780. I have not taken it off but am including three photos.Thank you,Martin

Hi. This is a roller from an Anderson screen door. I've found something very similar, but I'm not entirely sure if it's the correct item on your website. If you could provide any help, I would be grateful.

Having problems with 8' wide Arcadia sliding door installed in single family home in 1970. 1. The handle broke and needs replacement. I can't find a replacement handle. It has 3-3/4" screw hole spacing and the metal door frame is 1-5/16' wide. What do you have that can fit? 2. I am able to close ... (cont.)

Unfortunately, I do not have all the measurements or pictures that I need hoping you can identify it with the part number. If not, I'm at square one thanks for any help you can give.

Missing the window hand crank

Do you have a snap in glazing replacement similar to this. Dark brown color.

I have sliding windows with Push Release Sash Lock and Keeper Set as you see in the pictures. These sets are 12 years old and a few of them have the locking part that extends out (IMG_1065 in the set of pictures I sent) break one of their 2 prongs. Unless I can change this part, I need to change the ... (cont.)

Operator is stripped It measures 5" inside

Bought this house with two windows looking like this. Can you help identify which model I need to replace?

This is from a Scheirich cabinet / lazy susan. The plastic shelf edge has a lip on top that has broken over the years. I am looking for new shelf edge that I can install.

I need to replace the channel block and tackle window balance, it is on a Milgard window, the channel is 27 inches long. Which one do I need?

Hello Swisco, I need two each of the mechanisms pictured in 8027.jpg and the 8028.jpg and one each of the mechanisms pictured in 8030.jpg and 8032.jpg. Please email prices, shipping, etc. I live in a Fishers, IN Thank you, Brett

I recently purchased new hangers for my screen door thinking the original hangers were broken as they don't clip in completely. The photo I attached shows the clip furthest away from the door edge on both hangers doesn't clip in. Should the hangers completely clip in on both sides? If so, what mi ... (cont.)

I need new channel valance and shoes for the top and bottom sashes both sides

Hi; I am looking to replace a couple of balancing spring coil rods for my window. the pat number is 5.737.7.77 and it is 24.5 inches long from tip to tip, and the width of the T shaped shoe is 1 inch. the panel weights 24 lb. Pivot bar scew hole distance 5/8 inch ( from center to center). which pro ... (cont.)