Viewing all customer Discussions for:

Door & Window

Dear Swissco, Do you make a replacement lock for this patio door? I prefer one that has a keyed lock. The holes for the 2 attachment bolts are at 3" on center. I have done two prior on other patio doors using Swissco parts and consider myslef capable of doing this work. Thanks!

I am looking for a replacement Handle/Lock for a Simonton Patio Door. I think the 82-089 Handle Set and 82-218 Mortoise Lock Round Face will fit. All the measurements seem to match. Thank you in advance!

Need help with this glazing bead.

Good evening. I'm trying to identify a window balance for my customer and I was not able to find one through my normal distributors. This balance appears to not have a channel with a stamp to identify. Attached are some photos of what it looks like when it is installed. The spring diameter is 3/8". ... (cont.)

I am looking for 2-different balances for Loewen windows, 1-reads 15 and 1-reads 26. Is this something I can get through Swissco and if so what are the part numbers?

I have this truth operator that I need to replace. Your dual entry brand is close but the screw holes don't match up. Will your work for my needs?

Attached pls find 5 of the 10 photos. (Next 5 photos in 2 of 2 email). The problem being that the gears are stripped.

Hello, This window falls forward when open. I think this is because the tilt latches are broken. Could you tell me what I need to replace them?

I need to order 4 replacement parts for a single hung BFS window. The parts are the channel that help raise and lower the window. The 4 pictures above are the parts that do not work. All of the channels have 27-4 stamped on the side of the channel. All of the hooks that were on the end of the string ... (cont.)

hello, I am looking for 2 parts: the metal clip that connects the arm to the slider, (seen here in 2 pics one a close up). and the slider itself. I would like about a dozen of each.thank you,Charles

I am looking for a window Channel balance the marking on the bottom is 3030B.S.II

Hello, Seeking a replacement crank (Truth brand) for a Pozzi window. Please see attached photos. Happy to answer any questions or provide info. Looking forward to your reply, Karen

White version or black version would be fine. Part/ID numbers are on 2 of the photos. Do you only sale direct or are their storms where I might find in my local of zip code 64055?

Looking to replace Jeld-Wen window cranks. The part number is Jel-N-186, the finish is Oil Rubbed Bronze.

I need to replace the roller on the our Patio Door SGD-R20 180X96 door. Pictures attached can you please assist with replacement parts, also the seal, door dust protectors.

Do you by any chance carry this part ?Where the tongue is. There is a piece broken off. I am A Maintenance Supervisor at an apartment complex. Thank you Troy

These are the rollers on top of Stanley glass closet doors

I am getting ready to sell my home and I have several window cranks that need replaced. Both left and right. They are around 31 years old. They have "K/K" on them. See picture. Can you help? Thanks Ed

HelloSorry not sure what part is Looking for trim that holds glass in on the out side of house.Thank you for any helpBobby

I am looking for this mechanism and any associated parts, clips, guides, etc as if it was a new installation. Thank you