Viewing all customer Discussions for:

Door & Window

Dead bolt lock not working. Lock removed from door. Need replacement locking mechanism.pics attached.

Hi Do you have a similar wheel roller The measurementsWheel dia 11/4 inch17/8 long 1/2 inch wide, 1 inch deep Thank you

The windows are 3' x 4' . The balances fit in a channel. The dimension of the balances is 1/2 ' x 1/2 ' x 23 '. Each balance is stamped C2240. About myself: Homeowner, do-it-myselfer. I've changed out these balances before.

It's about an inch long and secured my storm windows into the frame of the window

I need to replace that part of the window

46” +\- threshold, and rollers

Wheel O.D. Is 2", width is ≈7/16". The assembly bodies seem much simpler than most of what task carry. I think the door is from the 50's.

It looks closest to your 81005 but it's slightly different where the unit screws into the frame. The label on the frame door says series 100/150

I tried to order this from Harvey and they said I need the warranty label which is not on any of my windows

Original window, 1979 house. Casement window, unknown brand. Inside thermopane reads Burton IGCG 140.... Crank handle insignia seems to be an r i? Or r with a head and shoulders.

Part number on the defective part is 13270811036

I NEED 2 OF THESE SETS

10

We are looking for some old MW window balances. The shaft (gray) is 27 1/4" long, the spring is 13 7/8" long, and the other parts are in the picture. Please advise if this is something you have?

I believe the window supplier was Jordan. This didn't fully match any of the ones you had displayed. The top fitting was similar to S350/S351/S390. The bottom fitting was similar to S370. It is approximately 24" long and 1/2" wide. I hope you have something that will work. Thanks. ... (cont.)

HELLO, I NEED TWO OF THESE SETS

Attached are pics of a side view, front view, and back view of what I believe are called sash guides. My windows have metal ones that I need a replacement for. The measurements are: 5/8 inch width 9/16 inch deep 1 5/16 inch long What's my best bet? Thank you.

The old balance springs are 27" long and have yellow tips. I attached a picture - apparently they had plastic covers which are mostly gone. I found a replacement but I'm not sure I have the right one. Also I need the attachment for the bottom of the window. It looks most similar to the red-tipped 2 ... (cont.)

Hello, I have an aluminum patio door w/aluminum screen. It is in Hawaii on a northerly shore, the door facing east to the predominant weather, & the intense rain & salt-water air has corroded the screen roller metal track at bottom. We pounded in place atop the existing track an extender tra ... (cont.)

Hello, I called a bit ago asking about balance springs. Here are pictures of the parts. They the aluminum body is 34" long and they have the numbers 3375 1jr stamped on them. Thank you!