Viewing all customer Discussions for:

Door & Window

Hi I need some help finding the replacement balancers. I have more pictures but it doesn't allow me to upload them all. I need a total of 6 round ones and pair of the squared ones. Thank you

Hi...my channel balances have a clip up to that secures the rope end to top of window & a plastic t that is at bottom that secures into show....the6ha be a marking that looks like 33 b & 32 b........pleas3 help me to identify.....the were double hung with a standard release clip at top to al ... (cont.)

Hello, I'm looking for any information possible for acquiring a replacement locket for our entry door. I see it's a Marks lock, but I haven't been able to find anything similar. Thank you for your time.

I AM INQUIRING ABOUT A CHANNEL BALANCE THAT I NEED TO REPLACE. THE MARKINGS ON IT ARE 26-14 GJ5 CMC 50. CAN YOU GIVE ME ANY INFORMATION ABOUT ORDERING REPLACEMENTS. Attached are the photos of our channel balance which is 27 inches long. I apologize for the quality of the photos. Let me know if you n ... (cont.)

Here are some photos of window crank and covers that need to be replaced. I ordered the incorrect ones with the hopes to find the right sizes I noticed 2 of my windows have a L in them and the others have a R in them I know I'll need two of each.

On the Side of the roller are the words:P E Del MarMADE IN U.S.A.Sizes are also in the fourth photo.Wheel is metal (1 1/4")Height (1 5/16")Length (2 7/8")Width (3/4")

Hi, I am looking for this lock parts. Do you have it?

Hello. I am looking for a replacement lock for a storm door with a sliding glass/screen upper window. The tongue that goes in to lock has broken off and the upper glass will not stay up. Thank you

Says 3520 from what I can tell on numbers. 36" channel with 1/2" across. Lawson SH-7500.

Hi, I have a couple windows that operate fine except the gears are stripped. The part appears to be the 39-020 but not sure. Do you sell just the arm as a replacement part?

(7) windows 29B (1) window 23C

Hi the window I have will not stay open, it's a rental and am working on it for owner I do not live there. Thanks Scott

Hi I have a awning window in so cal that needs new awing operator , track and this black piece that goes in track guide

Good Evening, I'm pretty sure I've identified part # 26-375 as the replacement part I need for a window. However, the part currently in the window has a channel/slot aalong the end of the pivot bar. Does part # 26-375 have a chennel/slot in the pivot bar? Thanks very much for your help.Jeff ... (cont.)

1. 27 inch metal channel 2. Stamp 26 4 3. Unknown 4. Total of (2) balances needed.

Need this part and not sure what it is in the inventory.

Hi. Latch on my patio glass slider broke. It's about 2 1/4 inch long. Uses single screw to attach to handle. Screw is small and included in picture. Do you have a replacement latch? Thanks,Joe

Images

From metal to metal it's about 12 5/8, wings on the plastic part top and bottom. Back of metal stamp says 12 5 B.S.I. OA.

Hello, We have Pella insert windows that need the seal replaced. What product do we need. I believe we have 17 windows between 24 and 36 inches wide. Thank you,