Viewing all customer Discussions for:

Door & Window

Looking for a replacement please!

I have large Milguard windows HS LC 25 with worn rollers that are noisy. Is the replacement roller 87-201 the correct replacement? Any special tools required?Regards,Garret

Hi. I am Cesar. I would like to know if you have this kind of pívot bars.

Both coil spring balances are at the bottom of the side window track. I haven't time to take them out yet too examine, but think I need new balances, but don't know which ones. Also, uncertain about the shoes until I remove them.

Looking for a window balance replace my for a Mayfair twin window

I have older American craftsman window in my house. Replaced 15ish years ago. I have a right hand 26 266 latch broken, according to what I read no longer available. Can the 26 393b or 26 393 be a suitable replacement? What would I need do to use them, only difference jumps out at me is they are sho ... (cont.)

Hi, I'm looking for a Milgard door hinge, HA6941HGSS. They tell me they don't sell this style anymore, and I need to replace three of them. The original hinges on this door were NOT stainless (I live near salt water), and you can see by the picture what happened. I also have a picture of the stainle ... (cont.)

I've been attempting to find a replacement for these and have had no luck. I purchased the closest I could find and it was still incorrect. Please assist

Replacement handle for Cole Sewell Storm Door # S6525, handle # HD630 Almond, Door was installed in 1999. The installer was The Door Store, Glenview, IL.

I'm looking to fix or replace the window handles for my many windows that crank open sideways.

This appears to be a TRUTH EntryGard casement operator. From the picture, you can see it is stamped 45275. It has two arms, but, unlike any of the EntryGard operators I've found on the internet, one of the arms on this one (the arm which goes in the rail), is short and is attached near the hinge edg ... (cont.)

I need a 12 screen corners measuring 1 3/16 is the bigger corner sqaure part and its 5/16 Thick 3/4 is the smaller part that goes into the channel for the screen and its 1/4 Thick

Milgard said they no longer make these parts and suggested you for a replacement. Can you confirm what part number it is?

Please see the attached pictures. This is what I am trying to get and cannot find it. Part of this one is broken where the screw goes through to attach it. I do not know the brand of window. The balances I purchased are correct, but I need these plastic pieces to hold them in place Let me kn ... (cont.)

Please help me choose the correct replacement rollers. I need 2. jack

I have a forever storm door model 536397 that I need to replace the door handle hardware. The plate on the outside measure approximately 2" wide x 7" high. The round handle is on the bottom and the lock is on the top. Inside are two separate latches. Please advise me what options you may have to re ... (cont.)

Additional pictures

I purchased item 82-089 sliding door handles on the advice of the forum but found the screw holes to be off from the original sliders US Patent 5125703 D340,398. I am wondering if item 82-086 on your website might have the proper placement for the screws. If so, could I return the original purchase ... (cont.)

I recently replaced the rollers (81-112) on my sliding glass door. I seems like the wheel bearings are sticking or something? The door is very hard to close. Is it possible to grease those bearings? I have used the wax on the bottom rail & that isn't helping. What am I missing?

Looking for replacement rollers