Viewing all customer Discussions for:

Door & Window

Can you please help to get the one which I need for replacing this, thanks

Hello, We have an Eli Validator screen for sliding door. The handle on screen broke and we were wondering if this would work as a replacement? Thank you.

Hi. Looking for this from a builder grade window. Thanks!

Seeking replacement window balance. Marked 26 5. Metal length approximately 26 3/4 to 26 7/8. Shoe appears to be 1" with flat bottom. I need two balances. Thanks in advance.

length: 25.75 Tilt window Stamped: 24 width: 9/16" No tabs on top fitting. The upper pin of the channel assembly hung on a hook inside the window track. No tabs on bottom fitting and it's not riveted to the channel. It's depth .375" in the direction shown is smaller than the channel depth .6 ... (cont.)

Looking for these replacement window latch pieces. Thanks

I have a single hung window that has no balancers. The window frame is 29 inches tall with 9/16 thickness. The main frame has a tab on each side 3/4 up the frame. Also main frame has little square hole and Little slot below it. These are located about 2 inches below the center of main frame. Wanted ... (cont.)

this is a window hinge for a late 70s Pozzi casement window. We have found that the plastic slide device is beginning to break down on some windows. I couldn't find a match in your online catalog. Number on the longer piece (7 11/16") that is attached to the window is 30147. The shorter piece (5 ... (cont.)

The ProFinish windows were purchased in 2000. I need one replacement tilt latch for the RIGHT side.

I need 3 white roll wheels for top of spells sliding screen door.

Good Afternoon, Attached, please find pictures of an Anderson window part that we would like to order. Almost all of these pulls used to open the storm window have broken. Do you have anything like this? Thank you, Diane/Todd

Looking for replacement pivot pins. Discovered some bent and broken during washing of windows. 2 inch base by one inch pin. House was built in 1996. Thank you.

I have these rollers and need to identify them. House was built in 2000. I think this has one side that broke off.

Good afternoon can you please help me identify the attached part I need to Order? thank you

We are refinishing these casement windows and are looking for weatherstripping options similar to what we have. Attached are pictures of dimensions and of the weatherstripping and the casement jamb.

Hello per your request these are the pictures of the current mechanism. I am looking for something that would allow the window to open fully so I have 20" clearance. Thank you.

Yes I'm trying to get a replacement part for a guardian mortise lock .Ans1297. 1-1984 safety tempered SGCC 2259 V8 U.

Hello, I am looking for 30 balance springs with the configuration of the photos. The windows are single hung vinyl.Thanksrob

Hi there, find attached pictures of products that I am looking for . Do you carry it and is it available in Canada? Thanks

We bought a used 2019 Winnebago Minnie 2500fl and the knob/crank for the window on the passenger side of the bedroom window is missing. I need to know what kind of knob/crank it uses. There is a label with the following number (and a lot more numbers) on it that start with D52769. ... (cont.)