Viewing all customer Discussions for:

Door & Window

Hello, I'm trying to match these with the inventory on your website. They are Truth hardware parts and I need top and bottom sets. The part numbers listed on these pieces are 31858 & 40986. We need right and left-handed. Thank you for any help you can give.

For BF Rich Vintage Vinyl windows. Balance spring is stamped'7'. Would like to buy new springs and the plastic parts (pivot shoe). No part numbers on the plastic parts. Help please! I did post yesterday but didn't have pictures until today. Thank you

Need top brackets to match 36-048 10" bottoms.

I have midwest stok 4000. 40WS27752. 11inchs. double hung. F1349192.1 27. 3/4. X. 57. 1/4. 6/22\ this is the only info I have on these windows. I'm looking for locks which some are broken..... Tilt swivel parts etc. CAN U locate these??

I'm needing the part where the balance hooks up to

Guessing circa late 60s, need 5 operators and other parts.

Both the fixed and the adjustable rollers are held in the bottom of the door frame by two steel tabs that were bent over the ends of the bases. The bases are both 5 1/2 inches long and 11/16 inches wide. The wheels appear to be nylon and are 1 3/4 inches in diameter and 7/16 inches wide. The sides ... (cont.)

Hi , could you help me to find which one is match my window ? Please check for me, I don't know which model is fit My part number is 2940 BSI

Can you please help in finding a replacement channel balance (attached photos). Length is 33 inches. Markings: 32 6 GV CMC 7

Good Morning.....Do you have a compatible replacement for the tie bar guides shown in the photos? Thanks for your help.Jim

Hi there, I'm in Orlando, Florida. I have single hung windows. Some windows won't stay up. The balances need replacing. I see the number 28 B stamped on it. These aluminum frame windows are original to the house which was built in 2005. I am looking to replace the balances. Also the plastic that is ... (cont.)

Please identify which part is better for the repair of my windows. The window middle lock is ok . The side plastic which has two screws are broken plastic.

Hi?you guys bailed me out last time I needed a part, I'm hoping you can help me out again. I just need the base part that the handle attaches too and the lock goes thru as in the picture. Can I just get that piece or do I need to buy the whole handle? I just got the lock latch from you a few months ... (cont.)

Viking Vikor elite brass door handle kit.

Hello! Can you help to identify the replacement part for this balancer? Thank you.

This is what I need to replace

Series 9500, double hung. SilverLine

I recently moved into a house which had this lock set up and I do not have a key. I need to know my best options with regard to getting that whether I need to buy a whole new handle or I can just get the lock cylinder and install it. Thank you

Please find attached pictures of what is left of sliding window wheels. I tried to look at the other ones in the unit and they were all gone. Hoping you might be able to help.

Numbers on pivot are 103 102 I'm wondering what replaced this one