Viewing all customer Discussions for:

Door & Window

Hello, I am in need of a replacement for "spiral balance" for my aluminum single-hung window. I am also not sure of the type of spring winding tool for this balance and whether or not I need 1 or two spiral balances. I am unable to remove the window in this high-rise building to install the balan ... (cont.)

I am looking for drawer pull handle replacements for Thomasville bedroom furniture. The holes are 41/2" apart. The part that screws onto the wood is fine. It is the pull that broke off. With light use we have several that need replacing. Thank you for your assistance.

I am in the need of 22 balances marked 3635 at 37" and 6 balances marked as 2950 at 30". I understand the 3635 and 2950 were originally made for ALCAN windows. What would you be able to provide to match these existing balance tubes. No I did not take the sash out an weigh each of them. Thank you ve ... (cont.)

Channel length (metal only): 20 13/16" Sash height: 23" Channel stamp: 2050 B.S.I. OA Pella fiberglass windows installed in 2007

Hello. I'm trying to locate this balancer. It's from an Armaclad sound solution window from 2013. This one is 13/16" thick, I need one closer to a 1/2" thick. Thanks,Seth

I have a casement windown with a broken tie bar and am looking for a replacement. I've included a picture of the broken tie bar as well as one which is whole. Would appreciate knowing the correct part to order. Thank you.

I need 10 of each size. My existing part shows shows the following number on it2425 BSI and 3230 BSI

I am looking for kerf weatherstripping to fit casement windows. They were manufactured by Republic aprox. 25 yrs ago.The height is 3/8"-7/16". The width at the top is about 3/8". Attached are photos that might help. Thank you.

Need to replace my broken window crank. See attached photos.

Hi, I need three balances that are 37". (measured just the metal piece) Thanks, -Mike

I marked in the pictures what it should look like when it's not broke, also an example of it being broke. I currently have four broken ones. The pin slides through a track that zig zags to lock in place. I don't know anything about the windows or the actual part

Frame latch for sliding screen

looking to see what you would have to replace this in a coil balance window. it is about 1 7/8" long and 9/16" wide.

Looking for correct balance 3/8 by 28" long

Door labeled as ALI ADW-8 ASTM 2190-ARG Need new handle and lock mechanism. Photos attached. Thank you

The model of this window crank is 39-393 Roto Vinyl Awning Window Operator : SWISCO? But it looks like you may have a different model. Please advise if you have the replacement for this one. Thank you!! Judy

The roller nor the door have any kind of numeration, names or letters. I'm just trying to find it without any success.

Hello, i want to order some replacement parts for my window and i wanted to know what the difference between the sash dyad crank and the window dyad crank? How do i know which one i need? Thank you for your help!

Hello, I need to replace a broken pivot lock shoe from a window without make or model info. I will replace both pivot lock shoes. The broken one is in image 1, it measures close to 1 inch, but could be less if it was whole. Image 2 is of a non-broken lock shoe from the same window on the opposite ... (cont.)

I have a Jeld Wen casement window that has an inoperable crank. The crank freely spins . The gears do not connect. The crank mechanism has a stamp reading Pat # 48040.075. That is the only ID information I can find when I removed the sash. Would someone please call me Thank you, Daryl ... (cont.)