Viewing all customer Discussions for:

Door & Window

Would you have these? 5" x 1.5"

Hi. I need an operator crank for an Anderson awning window. As you can see it is quite old. I hope you can help. Hole diameter - 1 & 9/16" Gear box area - 4 & 1/2" Back rod - 13 & 1/8" IMG_2017.jpg IMG_2016.jpg Thank you in advance.

My Marvin windows were installed in 2006. Several of the handles and covers are broken and need to be replaced. Primarily it's the crank handles and I can probably keep the covers. The handles are positioned in the middle. Sending photos with approximate sizing.

Need to replace my milguard casement hardware. Window does not close.

Would this work as a replacement for an Andersen Classic Series Operator for casement windows? I need something that is low profile to work better with window blinds

do you have a replacement for this biltbest crank for a casement window

Need help finding replacements.

The plastic housing of our old balance springs are crumbling to pieces.

Please help me find those parts

I need two (2) replacement channel balances. They are off single-hung Champion vinyl window. Movable window is about 3x3 (feet).Channel looks to be 5/8" (outside to outside)I have purchased from you before and had good luck.ThanksMatthew

I have a similar issue, lock handle to an Anderson casement window, fibrex from 2014, just snapped off. I was ready to order 39-291, but the shape seems different for left and right side. The lock handle we need is on the left side of the window. Here is a photo of the remaining handle and the o ... (cont.)

HI we are looking for the replacement roller for a aluminum sliding patio door. Pay close attention to the back side - its one Ive never seen and tried looking for it on my own.

'm in need of 2 pairs - total of 4 Please let me know if you have these available to purchase.

Our windows were built with plastic clips to attach to the window track, but with age a lot of them have broken. The corners of the screens appear to be sealed so I'm not sure a slide in clip will work. Any help would be appreciated, most of the screens will not hold in place anymore ... (cont.)

Looking to lock door again

- Metal channel length: 26 13/16" - Stamp: 26 3 - The windows were installed in 2005. I don't know the manufacturer. - I'd like to order 2 for now. If they work, I'll be ordering 126 more.

Hello, Swisco team. We have a window that has a cannel balance 2730 BSI and another one 2740 BSI. The length of them is 28" without the inserts.

Please can you check for me if you have same one same size, as you can see the bottom plastic part is smaller than i have. Thank you for your help

Looking for the correct part number to replace this left side tilt latch replacement. Thank you so much! Joel