Viewing all customer Discussions for:

Door & Window

These window cranks are from 1998 build. I have 6 of this type of crank that I need to replace/repair.

Please help identify this part and a suitable replacement for it. Thank you.

Metal length = 24", stamp reads, 23 4 JR CALDWELL

81/4 by 5

The mechanism to keep the window from falling out of the channel when tilting to clean outside window

Could you help me idenitfy which vent latch replacement model I should buy for these?

Hi I need help with this patio door handle. Ive supplied the gap in in the screws. Id like it in white

Hello. I hope you are well. I'm looking for these alenco Cam locks - these are white aluminum windows. House is about 30 years old a little bit more. I also need the sash balancers. I need a few of those - that particular window I sent you as a 30 inch tall operable sash. The window is a 4070 - also ... (cont.)

This looks similar to part I need replaced. Is it the same part number? 39-264?

This is on my casement window around the perimeter of the exterior glass

I measured, the best I could, the long arm being 8 3/4" the short arm at approximately 4"

Need this parts for I can assemble my window. Can't wait to hear back from you guys.

we are missing the locking latch on one of our windows. I am trying to share both the part that is missing and the part that it connects to. Jill

Looking for a part number to order two new slide in tilt locks the tip broke off of both of them

2015 era Milgard screen door. The corner bracket holding the spring broke.

Need to know the correct part to order

Dear Swisco, I'm looking for this replacement part for let and right side. Please let me know if you have them. Thanks, Q

Looking for left and right tilt latches 1-1/8" wide x 2-7/8" long x 2-1/8" center between holes. ... hole closest to window frame is 1/2" from end of latch cover

Hi looking for 2 of these tilt pins. Not 100% sure of the manufacturer

Length of Metal Channel: 25.5" inches Stamp: 25 5 B.S.I. RK The house with the window was made in 2006. We would like 2 balances. Please let me know if any other photos are needed. Thank you!