Viewing all customer Discussions for:

Door & Window

I need to identify the spring part #. The sash weighs 13 lbs. and the spring is 1/2 inch width.

NEED 4

Looking to find a snap in glazing bead for a small fixed sash

I don't see any identification numbers on anything

This is the runner of an old sliding door that used to go to a patio and now goes to an extension room ok the house, so interior. There are to of them, single roller each. I've tried finding parts at all of the box stores, but nothing seems to be the right one. please help.

The original part is stamped 32-5. Any way to figure out the correct replacement? The metal portion of the balance appears to be 33" long. The closest picture on your website appears to be the Series 395

Looking for replacement screens or the " pin parts" that are broken on the screens

I'm trying to find these balancers for a vinyl window, unknown make. I attached pictures of the spring loaded balancer and a sticker on the top of the frame.

26.5 inch channel measured full length of metal. Need 4 of these.

I am writing to request a quote for a custom sash weight balance.The specifications for the balance are: a weight of 10 lbs, a length of 28 inches including the swivel mechanism, and a length of 27 inches without it. I need one balance in total.Please let me know the cost, any associated shipping fe ... (cont.)

I have 7 windows 36wx55h, the balances are 26 1/2 long by 1/2 wide, it weighs 20lbs. I have 3 windows 28wx36h, the balances are 16 1/2 long by 1/2 wide, it weighs 10lbs. The windows are single hung tilt and the balances channels are 3/4 wide by 5/8 deep. I also need pairs of left and right latches c ... (cont.)

Hello, I am looking for replacement storm door window latches for our emco forever storm door , serial number 5010892. They are four inches long and 11/16 inches high, please see attached photo Thanks

Hello,I need to replace 2 - 29" spiral balances and the corresponding pivot shoes to be safe. These are approximately 30 years old. The weight designation for the "red" tip balances is what I surmised from another similar window given these didn't have any plastic tips remaining. Are there any other ... (cont.)

I have a broken window lock that's at least 40 years old. It appears to be made by Truth and there is a stamp "L20155" on one of the internal components, as you can see in the photo. I'd like to find as close a match appearance-wise as possible. Thanks!

please advise part numbers that will match spline 11/32' and color. Thanks

The latch has the name "Philips" on it and the length is 3 7/8 and the width is 3/8. The long part on the corner connector is 1 3/16. You have help before, so let's try again. Thankyou

I need to know what type of spiral balancers those are, I need in total: 4x - 12 inches length 4x - 24 inch length 12x - 17 inch length

Not sure if you have one of these thanks

The latch to my window broke off. Can it be replaced?

Attached are the additional pictures of #36888491 as of the telephone technical support discussion 15 min ago. Thanks much. ?