Viewing all customer Discussions for:

Door & Window

I am looking for this 80's vintage center mount roller for a monorail drawer mount. The roller is braded into the metal hardware. The draw mount hardware has a lip that fits over the back of the drawer to seat an align the roller hardware. The roller itself is about 3/16" wide as you view it from t ... (cont.)

Could you let me know what part to order based off the 2 photos?

The wheel says Kilian and Toronto and Syracuse on it. The main part is just over 1" tall and it is 13/16 wide. The wheel is pretty close to 1 1/8", but is pretty worn down so maybe 1 1/4". It is all plastic except the wheel is metal. The screw in the picture is not the right screw, it is the wheel a ... (cont.)

Good afternoon,I am sharing the pictures I took of the old channel balance that I can't really figure about to locate the extract replacement on your website. Please let me know if there is any further clarification needed. I would really appreciate your help. thanksHabib

23 inches length of metal. Stamp says 2230. No idea who manufactured window. Width is 1/2. I will need 2 of these.

Looking for a few pivot bars for my MI double hung windows. I have selected the correct pivot locking show (15-153) but am not seeing a pivot bar that matches this picture. The bar that enters the shoe is 1/2 inch. 1st hole is 1 1/8 from the end, meaning 1/2 in + 7/8 in. Next hole is another 3/4 ... (cont.)

Do you have a strike as pictured to work with your 90-323? The sash lock appears to match. 2-1/2 overall length, 3/4" overall width, 3/8" back wide, 1-3/8" strike pocket. Window markings: Series: Imperial 5000-HS P.L.# 98G-001 Thank You in Advance, Noel

Hi looking for the replacement parts as some have bent

This art keeps lower sash from opening more than 2 inches.

the metal bar is 21 inches, the stamp says 2030 B.S.I PK on it (its in a picture). I have already taken the balances off and just need the proper ones to put on. please ask for any more info you might need.

The only markings was a number 73 on the arm of the crank.

Can you check and let me know part number for both sides of window side railings length of old ones are 27"

There is a number 3019. A number100907

I need 8 bearings to replace the broken one in the photo above. The roller is 7/8 inch in dameter, the nylon roller is 1/4 inch thick, The entire bearing is .455 inches thick and the screw I believe is an M4. The screw is .475 inches in total length, .16 inces in diameter and the threaded portion is ... (cont.)

Looking for replacement or something that may be used I. Place of, 3/4" width, 1/4" raised snap for under window 1/16" thickness

Just the plastic part is broken. Do you have a replacement?

Installation instructions

Hi! I have a tilt window that had one of the spiral balance snap near the pivot shoe due to heavy corrosion. I included some close up pictures of that pivot shoe, the other shoe with the other balance still attached, and also the broken spiral balance housing after removal. I'll be replacing both ba ... (cont.)

was hoping you could help with some replacement parts.

I am looking to identify the plastic off-white piece pictured under the spring. We have the one for our lower spring but not the upper and it won't stay locked in place.