Viewing all customer Discussions for:

Door & Window

I have a client with metal windows like these, some of the one hole sweep locks are missing. Any suggestions on a replacement? Thanjs,.Richard

Looking for this operator

9D504 is stamped on the left opening hinge shown above. 9D903 is stamped on the right opening hinge shown above. I need both right and left opening kits including handles which are stripped out. Please let me know part number and order process.

I just spent $150 to replace the glass and the last remaining spring broke spring. Now both sides are broken. this is an old and likely very cheap vinyl replacement window. what else do you need to know to help me order new assemblies?

Sliding window up and down

The church is 1956 construcción

The Levers To Open The Screens From The Outside Have Broken Need To Replace 2 Openers What Parts Do I Order

Unable to locate any part numbers or other indicators, and have been unable to match with any patterns in stores

trying to figure out what to order. thanks

The windows with these coils are no longer staying up. I am trying to find a replacement or an alternative that can fit in the slots for the existing windows window. The length of the whole piece is 59.5 inches, the width is 3.5 inches and it is 3/4 inch deep. Thank you

Looks very similar to model 39-277 and 278, but the dimensions are: vertical distance between screws: 5 1/4" distance between the two bottom screws is : 1" , openning in the flat bar is 3/8". And the length of the flat bar between the two openings is 2 5/8"

I am needing some replacement channel balances and sash cam replacements and have attached photos. I think I am needing the 351 Series balances in 28". Let me in know if need additional pics or measurements

Need replace door lock/handle set

Patio door latch lever needed. I don't have the old one to compare

Metal part 28 inches long. 1/2 inch across closed side, 5/8 scross open side. Numbers on unit, 27 3 FT CMC 2. Top guide seems to have had wings, none on bottom.

I am not sure of the window manufacturer. It would have been assembled sometime around 1999 as that is the time my house was built. I have several windows that need the balances replaced but I am going to start with one of the smaller windows to make sure I can do it. I am not certain how to remove ... (cont.)

I work with Lee & Cates Glass in Yulee, FL. We have been searching for replacement window hardware for a customer with no success up to now. I have a few additional photos available if needed but hit the max to upload. The stamp on the balance rod is 33H. I need the balance rods, the end as show ... (cont.)

Hello, looking for this old style balancer clip.

Hi, I just moved into a new house and would like to re-key my sliding door. Is it possible to just get a new lock rather than having to replace the whole handle hardware? If not, can you let me know which item I should purchase and any instructions for install? Thanks so much!

Is this part available?