Viewing all customer Discussions for:

Door & Window

Hello, Looking for replacements for my current coil balances. Thank you!

Do you have anythoing like this corner? the finger pull part is about 3 3/16" x 3/4" it is one piece corner with finget pul;l (Retractable corner)

Please help id parts needed to repair/replace channel balance for two single hung aluminum windows. Thank you!

The photos evidenced are of a weatherstrip for a door. All images provided are fof the same weatherstrip.

Window crank mechanism and locking mechanism for Crystal Windows out of Queens New York. i need to replace both on a left side window. Thanks

Hi I took out these balancer and need one for each side of my window, I noticed one is shorter than the other

I need to replace the top flush bolt on a french door (72 x 96 opening). Photo shows the bottom flush bolt with the latch still in palce and the other shows the top flush bolt with the latch broken off. Please advise suitable repalcement for the top bolt or, if not exact matcch available, then su ... (cont.)

Here's info on screens I need parts for. One frame is 31 1/2 w by 22 1/2 h and one is 31 1/2 w by 18 3/4 h. The OD is 3/8 and the ID is 3/16. I need screen corner inserts for three frames and latches for two frames.

These plastic sleeves were inserted into 3/8 inch diameter holes in the window frame. They receive the plunger pins from a roof window screen. What are they called, and do you have any? THANKS!

truth casement window long arm: 8.5"- 8.75" (still installed, difficult to get an arm-to-center measurement)short arm: slightly less than 4"hinge: 10"-11" (difficult to be exact with the rust)

Looking to identify the above ballast

Please help me find these corners. We have the springs but the piece that holds them in is broken

please help identify

I need them for 4 windows.

Hello I recently bought new coils for my balance and the barrels won't fit. They are 4lbs coils. Just wondering if I need a bigger size. This is the previous one that broke. Let me know if you need more information. FYI, It barely doesn't fit, so maybe it's the size up. And if it is the issue, can I ... (cont.)

Clip to disengage channel rail

The balance won't come out without me doing some damage. Here is number I could get a picture.

CPD # ALS-A-38-00049-00002 Solid Vinyl - Welded - Double GLZD 13/16" IG DS LO-E ARGON

A helper yanked it out of the slider because the wheel was flat. Now it's broken.

Gears on the crank are stripped and the mechanism needs to be replaced. I cannot get the crank mechanism out without pulling off the lower frame of the window sill. The piece could have been installed in the 1950s when the house was built. Before I tear apart the window frame I want to make sure tha ... (cont.)