Viewing all customer Discussions for:

Door & Window

I have a larson strom door with invisable screen When you slide the window down the screen comes down I do not have the clip that holds the window in place when puled up. So it does not stay in place , but slides down enough to let cold air in I was wondering if I could buy this clip. Thank You For ... (cont.)

I am looking to order a replacement lock for the sliding glass door shown in the photos above. Please follow back with me at your earliest convenience. Have a nice day!

I ordered 18-009 with 5/8" width before, but it was too wide. Then I ordered 18-036 with 1/2" width, which was too narrow. The pictures compare my original sash guide to 18-036. Do you have a sash guide with 9/16" width that resembles 18-009 configuration? Derek

This is a plastic nub from the top of a Marvin Infinity window screen. There are two on top of each screen which hold the screens in the channel above them. Where can I buy them ? Many thanks.

I'm looking to add an exterior keyed lock to my existing sliding door. Would these picture provide enough information on what key lock and door handle set I would need?

I have a 35.5-inch Kawneer door. The problem I have is that the existing door sweep doesn't come in contact with the door sill plate. This results in a draft coming in from underneath the door. How can I resolve this?

I NEED A NEW HANDLE FOR MY SLIDING DOOR. IF YOU NEED MORE PICTURES, PLEASE LET ME KNOW. THANLS, ALAN

Hello, Wanting to replace mortise lock set if possible but current lock set is still usable but cannot locate key. I cannot find a name anywhere on the door. It's a full window door from Lowes. Want to replace the handles and plates with oiled bronze if possible, 2nd and 3rd choice would be black ... (cont.)

I haven't found any number on these but I know that's they are spiral balance.

I'm looking for a sliding door handle/lock mech, made back in late 70's early 80's, handle and lock are one piece, inside and outside. Unfortunatley the handle on the inside broke, the lock shows a red dot when locked and a green dot when unlocked. The handle has a wood grain sticker on it, are you ... (cont.)

Hello, How do I know out the correct roller for my doors? Thanks, Paul

I have identified my Casement-Window-Replacement-Operators as 39-027E 9 1/2". Now I need the short arm and pivot track as seen in the photo attached 358-1R. I need 1 right and 1 left. Thank you

I need balance shoes as above, almost 9/16 (35/64?) x 1 1/4 x 2 7/16. Windows weigh 8 lb, are 19 1/2" and 20 1/2". When I order, I will need 4 shoes; 4 anchors, since I am not sure of the condition of the anchors; and pivot bars if the new balance shoes don't have the same slot as the old shoes. ... (cont.)

I am looking for 30 of them. The sunlight has made the clipart brittle and they have broken on most of my windows. Any advice on where I can get replacements? Thank you Sandy

We need a stop measuring 7/16 inch by 9/16 inches Thank you

need ten tubes they are 30 inches long , can you identify from pictures Thanks Ron

I think this is your 82-238 lock.It has all the measurements as your 82-238. Am I correct? J parker

So I order that piece, 82-244 and need to send it back because of the depth. It is not alike. Sending pictures. Any recommendations?

Please help me identify the replacement locks I need to get. The kind I found in local hardware stores have too short of an arm that swings out and doesn't catch the part on the window. The 1st pic I loaded shows the too short one.

Do you have these plastic clips which keep the storm window in its tracks? Both of these are broken but the bottom one is still serviceableThanks for any help you can giveChuck M