Viewing all customer Discussions for:

Door & Window

Hi there, I'm looking to replace my window shoe balance. The number shown on the pic above is PAT # 4610108 last number is hard to see but looks like it may be an 8.

My bank vet has a stamping of 29-9 cmc 11. It appears to be a 390 series. Which 2 would I order? It is for a pgt non tilt window.

My window crank operator looks similar to this one, but my dimensions are 2 3/8? instead of 2 1/4? and 1 1/8? instead of 1 3/16?. Do you know if it will still fit? Is there another operator that will work better? Thank you.

Found these window screens in backyard of manufactured home i just bought. Went to install screens and corner pieces are like dust. Cant id them thur your store. Perhaps you can help.Also, i will be needing some additional screens. Do you have all the parts to build screens. Thank you. I have purcha ... (cont.)

Please help me identify my parts. The counterbalance is 9 in and has tabs. It is manufactured by Caldwell. Please see pics. My parts have a stamp on it that says 83 FN.

Hi, I have a house full of Philips Windows and am under contract to sell. The house was built new in 2000. The broken sash appears to be made by Caldwell, #31 9 38 LN. I measure the metal length at 32" and I think it is 1/2' wide. The weight of the sash itself is ~ 38lbs, big window. I am looki ... (cont.)

Hello, I need to replace a couple sets of channel balances and am hoping you can help me hone in on the correct parts. The first 4 pictures starting with the one stamped with a "30" on it are all from the same channel balance. The metal part of the sash is 31 inches. The last picture with the "15" ... (cont.)

Can you tell me which one is the part I need to replace this broken part?

Bubble is 3/16 and t is 1/4 "

Please help in identifying parts

Black plastic sash cam. Total Length including cap= 1 3/8". Width of shaft= 5/8".. Depth of shaft= 5/8". Length of shaft= 1 5/16" Cap dimension is 7/8" wide x 11/16" deep.

Vinyl window replacement parts needed for tiltout Windows installed in 1995.

Need this indentified

My vinyl glazing is for a baement window. It measures 0.48" wide at the base. It is 0.3" tall. It has a 0.1" foot at the bottom the vertical edge. It has a 0.03" lip on the sloped side (0.12" from the bottom of the slope)

This piece slides in the track as the window pivots open and closed if It is bent,preventing the window from closing fully.

Need to find replacement balances for Milgard - vinyl 'Style Line' single hung windows. Metal part of the balance measures 31 5/8"

Do you stock a replacement part for the small, clear plastic part that images 7478 and 7479 in the three attachments show near their center? In the attachments, it's the clear but grayish looking plastic part, that is held in place by the Philips head screw and is designed to hold the sliding parts ... (cont.)

Good morning! My window are from 1987. The channel balances are all missing one thing or another. I would like to begin replacing all of them ( a mere 60!!!) They are 29" and considered 1/2" from what I can measure according to your direction yet the stamp on the side reads 28 2 ? What do I need t ... (cont.)

Vinyl window pivot shoe and balance. The pivot shoes appear different (and broken pieces) on each side of the same window and the window has a hard time moving up and down. I'm not sure if the balance needs to be replaced too.

This window latch for a window is by Paramount