Viewing all customer Discussions for:

Door & Window

Need help in determining the channel balance replacement for my window. Attached photos of it ! Any help , will greatly be appreciated

2 3/8" left and right. I have only been able to find 2 5/8" which are too big.

I definitely need 1/4" legs, but I need a bigger square. Do you have anything like that?

Not many markings but it looks like a 31.5" balance. I ordered some previous which are the wrongs size, and now need to send back but thought you might help me get the right replacements

From my measurements, I've determined I have an Andersen Narroline Series 200 model 3846 and that the replacement sash balance for this window is part 1133. Unfortunately, the balances I am replacing have no stamped part number that I can find, but perhaps you can confirm my determination from view ... (cont.)

Need part numberGreg

It's me again. How do I identify these balance SHOES? Also, do I really need that white spacer thing? (one pic shows it with correct alignment, other pic shows it jammed at an angle). Do they come with the shoe or do I order them separately? regards,Eric

The piece I am looking for is a retainer strip for a thermal glass unit in an aluminum frame. It is about 3/4" wide, plastic.

I have a white vinyl windows installed 3 years ago that I need 6 -8 clips (I?ve included photos of). Can you mail to me?

Hello,Could you please help me identify which chanel balance I would need. The with on the photos provided is 1/2" and the height of the metal part is 27". Best,Jenny N

Cannot find Balancer 2320 with black plastic top that screws to window's track end cap.Please help identify balancer needed.Non tilt window, ½" wide and 24" long.Top black plastic piece has hole for screwing it to window channel cap.

This is a custom entry door at a house built approximately 20 years ago. There are no markings on the door.

Hi I need a new coil balance spring (see photos). The old on is 1/2 inch wide and the window panel is 17lb in weight. There appears to be a number 9 embossed on the spring. Can you help identify this part please? Thanks Mark

Please help identify this operation mechanism for an Anderson casement window.

I need a quantity of four half-inch window valances identification number is 2540 but I don't see any with the correct bottom tabs let me know how I can order these thank you Andre

Trying to find the correct balancer for my Milgard window. The model is H-C35-108x90 (mull) .

I need help finding the right opener.

White glass glazing spline... 7/16" total width (5/16" width going over glass, 2/16" into frame), 1/8" height, 3/8" curved part that goes in frame.

Wondering if you have anything like this. I believe it is from a 60s large bay window storm window. Height is 15/32". Width is 1/8". Smooth side (on bottom in the picture) is about 1/4". The smooth side on the top is 1/8". And the hook part (bottom right) is 1/8". I could not find anything to match. ... (cont.)

Attn: Customer Service, I was not able to find this item on your website, but I'm hoping you may have a substitute. Thank you for your help, Andrew @ Flint Glass Service