Viewing all customer Discussions for:

Door & Window

I need to order some new channel balances for some non-tilt CWS windows. The code at the bottom is only three numbers spaced like such 22 5 followed by a small RD then large BSI. The dimensions I have measured is the metal 23", 9/16" width, and 1/2" depth (most people are saying theirs are 5/8" bu ... (cont.)

We have a 20+ year old aluminum and glass door and we need 4 new brackets for the handles. I have attached 2 photos as well as a sketch with measurements on the part we need. There were no markings on the handle itself and any markings on the actual door were too faded to read. Thank you. ... (cont.)

Metal latch needed for sliding glass doors.

I would like to know where I can buy 4 of these units.

Hi Swisco,Please forward to help select hardware. The photo shows the length, 30 inches, the terminations and not shown, 30D stamped on housing. Need to confirm an order for two of the proper balance. Recently replaced OEM Pivot shoe balances with SWISCO Series 795 T-Lock shoe balances.The shoe chan ... (cont.)

It looks to me like these part numbers, but I have attached pictures, so please check me on this:150-004 shoe19-005 top guideChannel width is 9/16Length is 9?I didn't see any on the site that are this short.The left and right ones in the window are different. The one with the shorter string is the o ... (cont.)

Old storm door. Looks like lead corner. 1.5" x 1.5". I would guess one of the larson kit sets. Can i buy this as a set and not the other type?

Hi!I have about 6 or 7, maybe more (need to check them), Lawson windows (non-tilt) that need new channel balances. The windows are about 11 years old. The plastic parts are breaking, or the string or some have the small metal pulleys cracking and breaking. Should go for replacing the entire assembly ... (cont.)

Heavy duty door rolls

I believe this helps to hold up the windows on philips windows.

I believe that I will need the tandem set up using 15-087 and 15-086. The spring has a stamp of 4Y, is this a 4 lb spring? When I install the the two coil housing, I assume that I hook them together and then pull the spring out and run one on top of the other up to the clip. Thanks you. ... (cont.)

The length of the balance is 30". The depth of the shoe is 1 1/8". The stamped markings are 29 4 BS1. Thank you.

I don't know the manufacturer but I need this piece that allows me to lock my crank windows. Any help would be greatly appreciated.

Need two replacement rollers

How do you replace slide bolt assembly 91-179?

Need to replace this part (window latch for silver line product ID 2901)

Help me find this please!

Where to find them. Easy to install

I think this is a tight hand window sash lock. The collie is champagne, but I'll take any color I can get. It may be a Caradco or Truth brand.

When I take latch out measurements are 1/2? wide x 4 5/8 high. Which latch do I need I do not see sizes of hole requirements. If you could let me know part number looking for. Much appreciated Thanks