Viewing all customer Discussions for:

Door & Window

Part is 2 1/8 inches long and as close as I can measure 1 1/8 wide. Do you have replacement?

It is the locking mechanism of a sliding door.

I need replacement pivot shoes. please reply with the details you need to match what I have. these windows are late 70's units. the pot metal shoe that pivots has broke on one side. the track does not have a removal slot. I need info about the track spreaders or another way the remove the shoes. if ... (cont.)

About 32 or 31 inches, skinny channel. Has markings of 28c.

I?m sending you pictures mybe you can help me with my lock Thank you

the balance measures 28 inches of steel (excluding the attachments on either end) and has the following stamped on the metal: 27 4 GW CMC 11

I purchased 15-118 to replace the pictured pivot shoes. The new pivot shoe will not allow me to hook the spring tip without modificatio. The pivot bar when I have to replace two of them, will allow my window to slide out of one or the other of the pivot shoes . I am using a 900 - 29 spiral balance ... (cont.)

Do you have a replacement for this handle ?

I am looking for a replacement screen door track for a Crestline patio door. The track is a 9/16 w x 1/2" h x 72" L I have been unable to locate one. Can you help me?

I need lock mechanism for my silver line sliding door

Non tilt window and is the bigger one the width

I am looking for the part that connects the sash to the metal rod in each side of the window frame. The part hooks on to the metal rod and has a slot for the small rods that stick out of the lower sides of the sash.

Hi, I am looking to see if you have the parts shown on the pictures, they belong to a glass door from a home build in the 50s. I need about 12 of those rollers.

Existing pivot shoes are 1/2 thick 1 1/4 wide and 2 1/8 tall The other photo is spiral balance retainer which is inserted into the sash track I need pivot shoes that work for spiral balance and pivot bar item #26-398

Could you please identify this roller for me? Have customer that needs them replaced and having hard time finding. Thanks Screen Man

Some of my Pella doors and casement windows make a sucking sound when opened. They operate fine but the sound is really loud and annoying. Any way to mitigate this sound? Tks!

I have removed the corners from my Jeldwen patio screen door. The dimesions you give for 95-020 are correct but I am wondering if the length of the 95-020 would match my corner. I have attached a photo of it. If I place my corner in the same position as shown in the 95-020 photo, the height of ... (cont.)

The above pictures show three views of the latch I am trying to replace. There are no identifying marks on the latches. You can see from picture 1260 above that the tip of the latch has broken off. I have quite a few windows that need to have the latches replaced. Dimensions are as follows (as ... (cont.)

Measurements match up with 26-442,but there's a spline right below the surface that let it slide into the window ( check photo). Also there is squared top(not radiuus). Part is stamped "P 23" on bottom.

Windows Miami 1950 operador trying to find a part of maimai window 1950 operator