Viewing all customer Discussions for:

Door & Window

this window latch is one piece and attaches to the window frame via back screws. the thumb movement of the window latch is broken. do you have a replacement part? thanks, Al Stephens

Hello I am looking to replace some window operators because the hect is stripped. Can you tell me if you sell an operator similar. thank you

Part for a true french door.

Here are some photos of the windows and the glazing. There are two sizes of snap in glazing on this window one of which you have on your site - the 11/16 by 19/32 (part 55-009). This second piece of glazing has a shorter front side and measures 7/16 by 19/32 and fits in around the aluminum munti ... (cont.)

Need to replace or repair patio door lock - the spring inside has quit holding flip lock in "lock" position. Do you sell parts and or total sets? Photos attached:

I am looking to replace my brass hinges with nickel ones. Where can I find replacements?

Looking for replacement window locks (both left and right) of the attached style of lock.

I'm trying to find this replacement part.

please provide me with size I need to order 4 sets(8)

Need replacement unit

looking to replace 2 1/4" white flush keeper window sash lock with 1/2" setback. Keeper is 1 3/4' overall height with mounting holes @ 1 1/4 c.c.

Looking for replacement parts for Pennco tilt windows. The pivot slide cam lock die cast center or complete pivot lock shoe assembly. Photo 1 & 2 are the pivot lock assemblies left & right sides. The right side has a broken die cast center (cam?) Which needs to be replaced. Can you help? ... (cont.)

Plastic piece has the number 2002 stamped inside. It measures 5/16" wide on the bottom and 3/16" on the top. Height is 9/16". Length (outside) is 1 7/8" Snap in glazing for same windows - piece looks similar to 55-196 and 006. it is 3/4" wide and the back flap is 5/16"The only protruding edge is a ... (cont.)

I am looking for the left-opening version of the plastic door latch assembly originally made by Likit windows of San Leandro CA. The Company is out of business. The black-colored right-opening version is pictured. Thanks! (Please note that the attached picture should be rotated 45 degrees clockwi ... (cont.)

Hi, I have looked at your 26-351 and it isn't quite right altho perhaps I can use it anyway. the ones that I have have two holes on top on no right angle piece on the edge with another mounting hole. the entire piece is 1 and an eighth inches wide and 2 and 7/8 long not counting the triangular sli ... (cont.)

My metal hook/clip is broken. It?s the one that attaches to the cord. Can I get a replacement clip? 1420 bsi vv Metal track is 14 7/8 long, 1/2 wide, 5/8 deap

Hi- I'm looking for two of the pictured roller parts and then ~10 rollers for parts that I do have.

Can you see from the pictures what might be needed here?

Hi, I am looking for the block and tackle rods for vinyl MW windows. Plastic clip on the top of the block and tackle have started to break.

Hi, the rollers in my Milgard sliding door are worn (dual wheel roller bearings) out and the door is difficult to open and close. I have have removed, cleaned and inspected them. Mounting holes are 5 3/4" Center to center. See pics... Any help you can provide is greatly appreciated! Brian ... (cont.)