Viewing all customer Discussions for:

Door & Window

Does this item come with the appropriate screws?

I need to find the clear plastic connectors (bushings?)to be able to connect the crank with the window levers. If it matters the crank is 4 1/2".

As I go through the process, by process of elimination it appears that S380 is the match for my window channel balance. One question; the top shoe that comes with it (the 19-005) seems correct in terms of measurements but the picture seems to show a wing at the top of one side of the shoe. Note that ... (cont.)

What width door will this track fit? My replacement screen door is 1/2"

I hope that you can see this handle. I have these parts at my house, but these are off my son's home. I installed this storm door some years ago. The big outside handle I can wiggle it off, thus I think I should probably replace the whole handle, but that is your call. We do not need a key lock a ... (cont.)

I'm looking for a plastic round roller wheel that fits on the botton of the drawer for a metal desk. It's about 3/4" and center is empty.

On the 39-234 operator, how long is the operating handle on the gearbox and how far does the torque bar fitting extend from the gearbox also? Thanks for any info, I'm trying to replace a unit that only has the numbers 887106 on it.

I was wondering can I get replacement parts for my windows. Thanks Susan

Hey I'm wondering the width of the concave wheel on the 75-016. Not the diameter of the wheel. The width of the edge that is concave, that actually touches the spline.

We are trying to install a window balance to repair our vinyl window. But we need to know the proper name of the white vinyl part displayed in this photo so that we can purchase it. If you could, where can we buy this part? Thanks in advance.

Need to replace this part on two windows. There are two on each window. Sticker has no brand name. Series 7000 SH/J channel H-R30 H-R40. It is about 4 1/2"L x 1"w x 3/4"D. Roughly. One screw.

I am a homeowner in south Florida with Alcan windows with brittle plastic glazing. Your suggested 55-092 looks very close and would be willing to try it, but does it come in bronze color???

Hi, I am looking for a replacement for my patio door. I have a serial number of my patio 298178-2-2-2. I am not able to tell what brand is my patio.

Window Balance is 27" metal end-to-end. Markings are: 26 4 EW CMC 4

Windows purchased at Home Depot 17 years ago. Vinyl single hung, spiral balance and tilt in. Bottom bracket rusted away. Round hole (3/8") in side of sash and 2 screw holes in bottom (1 1/2" and 2 3/4" from edge) for bracket. What bracket do I need? Thank you.

The covered spiral balances have popped and looking to replace them, I'm not sure what other information to include like HxW of windows?

This part stops the rod to take out window

Hello, Here are photos of the old part. The dimensions of the metal are 30" tall, 9/16" channel depth, and 5/8" width. The marking on the window balance is 29 4 GW CMC 7. The window sash weighs 20 lbs. What part # should I order?Thank you, Simon

My balances seem very similar to your 795 with the exception of a groove in the bottom of the channel and a hook on top as depicted in the attached pictures. I have many wiondows and my balances are primarily 33D and 25C. Hope you can help with my unusual balances. Thank you, Charles ... (cont.)

I've attached photos of the window mechanism for my casement window that needs to be replaced. Do you carry these parts? This is for the right side and I would also need the left. Thanks! Jeanne Burkett